From mboxrd@z Thu Jan 1 00:00:00 1970 From: eric@eukrea.com (Eric =?ISO-8859-1?B?QuluYXJk?=) Date: Fri, 21 Mar 2014 22:23:20 +0100 Subject: [PATCH] ARM: i.MX6: update KSZ9031 phy fixup In-Reply-To: <1395421687-12934-1-git-send-email-hchaumette@adeneo-embedded.com> References: <1395421687-12934-1-git-send-email-hchaumette@adeneo-embedded.com> Message-ID: <20140321222320.14370739@e6520eb> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Hubert, Le Fri, 21 Mar 2014 18:08:07 +0100, Hubert Chaumette a ?crit : > > Update KSZ9031RN phy fixup for Congatec conga-QEVAL and conga-QMX6 combo : > set RGMII GTX_CLK and RX_CLK pad skew to +0.96ns. > > Signed-off-by: Hubert Chaumette > --- > arch/arm/mach-imx/mach-imx6q.c | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/arch/arm/mach-imx/mach-imx6q.c b/arch/arm/mach-imx/mach-imx6q.c > index 76e5db4..db307c2 100644 > --- a/arch/arm/mach-imx/mach-imx6q.c > +++ b/arch/arm/mach-imx/mach-imx6q.c > @@ -77,6 +77,9 @@ static int ksz9031rn_phy_fixup(struct phy_device *dev) > mmd_write_reg(dev, 2, 5, 0); > mmd_write_reg(dev, 2, 8, 0x003ff); > > + /* For Congatec conga-QMX6 board */ > + mmd_write_reg(dev, 0x02, 0x06, 0xffff); > + > return 0; > } > that's board specific (the needed delay depends on the routing delay on the PCB), so this should not go in a generic file. Eric