From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@free-electrons.com (Maxime Ripard) Date: Mon, 5 May 2014 17:46:45 -0500 Subject: [PATCH v10 15/15] ARM: dts: sun7i: Add basic support for the Cubietruck WiFi module In-Reply-To: References: <1399046249-19472-1-git-send-email-hdegoede@redhat.com> <1399046249-19472-16-git-send-email-hdegoede@redhat.com> <20140505040212.GC11606@lukather> Message-ID: <20140505224645.GC9464@lukather> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Mon, May 05, 2014 at 12:20:56PM +0800, Chen-Yu Tsai wrote: > On Mon, May 5, 2014 at 12:02 PM, Maxime Ripard > wrote: > > On Fri, May 02, 2014 at 05:57:29PM +0200, Hans de Goede wrote: > >> From: Chen-Yu Tsai > >> > >> The CubieTruck has an AMPAK AP6210 WiFi+Bluetooth module. The WiFi > >> part is a BCM43362 IC connected to MMC3 in the A20 SoC via SDIO. > >> The IC also takes a power enable signal via GPIO. > >> > >> The WiFi module supports out-of-band interrupt signaling via GPIO, > >> but this is not supported in this patch. > >> > >> Signed-off-by: Hans de Goede > > > > It doesn't have Chen-Yu SoB. Chen-Yu, are you fine with adding it? > > My apologies, I didn't notice this patch still had my name on it. > Looks good. > > Signed-off-by: Chen-Yu Tsai > (or Acked-by, not sure which applies in this situation.) Since you're the author, we need your SoB. If you were not involved with writing (or merging the patch), Acked-by would have been appropriate. Maxime -- Maxime Ripard, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: