[PATCH resend 03/15] arm64: defer reloading a task's FPSIMD state to userland resume

[catalin.marinas@arm.com (Catalin Marinas)]

On Thu, May 01, 2014 at 04:49:35PM +0100, Ard Biesheuvel wrote:
> @@ -153,12 +252,11 @@ static int fpsimd_cpu_pm_notifier(struct notifier_block *self,
>  {
>         switch (cmd) {
>         case CPU_PM_ENTER:
> -               if (current->mm)
> +               if (current->mm && !test_thread_flag(TIF_FOREIGN_FPSTATE))
>                         fpsimd_save_state(&current->thread.fpsimd_state);
>                 break;
>         case CPU_PM_EXIT:
> -               if (current->mm)
> -                       fpsimd_load_state(&current->thread.fpsimd_state);
> +               set_thread_flag(TIF_FOREIGN_FPSTATE);

I think we could enter a PM state on a kernel thread (idle), so we
should preserve the current->mm check as well.

>                 break;
>         case CPU_PM_ENTER_FAILED:
>         default:
> diff --git a/arch/arm64/kernel/signal.c b/arch/arm64/kernel/signal.c
> index 06448a77ff53..882f01774365 100644
> --- a/arch/arm64/kernel/signal.c
> +++ b/arch/arm64/kernel/signal.c
> @@ -413,4 +413,8 @@ asmlinkage void do_notify_resume(struct pt_regs *regs,
>                 clear_thread_flag(TIF_NOTIFY_RESUME);
>                 tracehook_notify_resume(regs);
>         }
> +
> +       if (thread_flags & _TIF_FOREIGN_FPSTATE)
> +               fpsimd_restore_current_state();

I think this should be safe. Even if we get preempted here, ret_to_user
would loop over TI_FLAGS with interrupts disabled until no work pending.

-- 
Catalin