[PATCH] ahci: imx: PLL clock needs 100us to settle down

[shawn.guo@freescale.com (Shawn Guo)]

On Sat, May 17, 2014 at 10:58:20AM -0300, Fabio Estevam wrote:
> On Sat, May 17, 2014 at 9:46 AM, Shawn Guo <shawn.guo@freescale.com> wrote:
> > The commit e783c51 (ahci: imx: software workaround for phy reset issue
> > in resume) calls imx_sata_phy_reset() to reset phy immediately after
> > SATA MPLL is enabled.  It seems working fine mostly, but fails in some
> > case as below.
> >
> > ...
> > ahci-imx 2200000.sata: failed to reset phy: -110
> > ahci-imx: probe of 2200000.sata failed with error -110
> >
> > After talking to the designer, we learnt that when enabling i.MX6Q SATA
> > MPLL, we need to wait 100us for it to settle down for safety.  Add this
> > required delay to fix above failure.
> >
> > Signed-off-by: Shawn Guo <shawn.guo@freescale.com>
> 
> On my sabresd board that was not connected to any sata disk I was
> always getting the 'failed to reset phy' error.

Damn.  I never noticed that the error is even there when no SATA disk is
attached.  Sorry.
> 
> With this patch the error goes away and the driver probes successfully.
> 
> Tested-by: Fabio Estevam <fabio.estevam@freescale.com>

Thanks.

Shawn