[PATCH 1/2] ARM: i.MX: Migrate Freescale i.MX27 IP Camera board to devicetree

[shawn.guo@freescale.com (Shawn Guo)]

On Fri, Jun 13, 2014 at 07:21:06PM +0400, Alexander Shiyan wrote:
> Fri, 13 Jun 2014 12:15:21 -0300 ?? Fabio Estevam <festevam@gmail.com>:
> > On Fri, Jun 13, 2014 at 3:56 AM, Alexander Shiyan <shc_work@mail.ru> wrote:
> > 
> > > +       regulators {
> > > +               compatible = "simple-bus";
> > > +               #address-cells = <1>;
> > > +               #size-cells = <0>;
> > > +
> > > +               reg_5v0: regulator at 0 {
> > > +                       compatible = "regulator-fixed";
> > > +                       pinctrl-names = "default";
> > > +                       pinctrl-0 = <&pinctrl_reg5v0>;
> > > +                       reg = <0>;
> > > +                       regulator-name = "5V0";
> > > +                       regulator-min-microvolt = <5000000>;
> > > +                       regulator-max-microvolt = <5000000>;
> > > +                       gpio = <&gpio6 9 GPIO_ACTIVE_HIGH>;
> > > +                       regulator-always-on;
> > > +               };
> > 
> > I don't see this reg_5v0 regulator being referenced anywhere.
> 
> I just used IPCAM RM.
> 
> > Anyway, I am fine if you simply drop the board support file for the mx27 ipcam.
> > 
> > No need to add a dts for it, as I don't have access to this board anymore.
> 
> If so, I will send a removal patch for this, Shawn?

Yes, please.

Shawn