[PATCHv3 4/7] arm64: Move some head.text functions to executable section

[mark.rutland@arm.com (Mark Rutland)]

On Thu, Aug 21, 2014 at 10:42:13PM +0100, Laura Abbott wrote:
> On 8/21/2014 3:34 AM, Mark Rutland wrote:
> > Hi Laura,
> > 
> > On Thu, Aug 21, 2014 at 02:20:36AM +0100, Laura Abbott wrote:
> >> The code in the head.text section of the kernel exists in the
> >> same section as the swapper_pg_dir which means it needs the
> >> same page table permissions. The swapper_pg_dir needs to be
> >> writeable but shouldn't be executable.
> > 
> > I think we can drop the above. As far as I can tell as of commit
> > bd00cd5f8c8c (arm64: place initial page tables above the kernel) it's no
> > longer relevant.
> >
> 
> Yes, this should be changed. Instead of citing swapper_pg_dir, I need
> to cite the fact that there may still be memory outside of stext which
> will get freed to the buddy allocator and therefore should be RW/NX.

Ok. I must be missing something here; we don't seem to free any of
.head.text to the buddy allocator at the moment. Are we just trying to
have the bare minimum remain executable regardless?

> >> The head.text section
> >> is intended to be run at early bootup before any of the regular
> >> kernel mappings have been setup so there is no issue at bootup.
> >> The suspend/resume/hotplug code path requires some of these
> >> head.S functions to run however which means they need to be
> >> executable. We can't easily move all of the head.text to
> >> an executable section, so split it into two parts: that which
> >> is used only at early head.S bootup and that which is used
> >> after bootup. There is a small bit of code duplication because
> >> of some relocation issues related to accessing code more than
> >> 1MB away.
> > 
> > From a cursory glance it looks like the only things we need write access
> > to in .head.text are __cpu_boot_mode and __switch_data. Can't we instead
> > place those in .data and make .head.text executable?
> > 
> > We currently find them with adr, which should be easy to replace with
> > adrp + add to get around relocation issues.
> > 
> 
> __boot_cpu_mode should be placed in data with a push section and
> __switch_data is only modified before the permissions are set up.

Ok, so those are fine then.

> I took a closer look at the code and the only thing that actually
> needs to be executable from head.S is __secondary_switched so
> the following patch should be sufficient to cover it:
>
> diff --git a/arch/arm64/kernel/head.S b/arch/arm64/kernel/head.S
> index caa9557..5c17599 100644
> --- a/arch/arm64/kernel/head.S
> +++ b/arch/arm64/kernel/head.S
> @@ -414,12 +414,14 @@ ENTRY(secondary_startup)
>         b       __enable_mmu
>  ENDPROC(secondary_startup)
>  
> +       .pushsection    .text, "ax"
>  ENTRY(__secondary_switched)
>         ldr     x0, [x21]                       // get secondary_data.stack
>         mov     sp, x0
>         mov     x29, #0
>         b       secondary_start_kernel
>  ENDPROC(__secondary_switched)
> +       .popsection
>  #endif /* CONFIG_SMP */

If we need to cover __secondary_switched, don't we need to cover
__turn_mmu_on as well, given that will turn the MMU on and branch to
__secondary_switched?

Thanks,
Mark.