From mboxrd@z Thu Jan 1 00:00:00 1970 From: bonbons@linux-vserver.org (Bruno =?UTF-8?B?UHLDqW1vbnQ=?=) Date: Mon, 20 Oct 2014 22:33:14 +0200 Subject: [RFC Patch 1/4] mfd: AXP20x: Add power supply bindings documentation In-Reply-To: <20141020215954.7f1d5502@neptune.home> References: <20141020215954.7f1d5502@neptune.home> Message-ID: <20141020223314.0484f795@neptune.home> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org --- Note: the OCV values seem to have some defaults build into the PMIC though may need adjustment if the used battery has a different open circuit voltage curve. As far as understood (these values are set in vendor driver but not mentioned in chip documentation) they represent charge percentage for some predefined voltages. If prefixing these values with "x-power," is preferred the following patch should becomes a dependency: http://lists.infradead.org/pipermail/linux-arm-kernel/2014-June/267606.html and users in patch 2/4, 4/4 need adjusting. Documentation/devicetree/bindings/mfd/axp20x.txt | 20 + 1 files changed, 20 insertions(+), 0 deletion(-) diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt index cc9e01b..8ea681c 100644 --- a/Documentation/devicetree/bindings/mfd/axp20x.txt +++ b/Documentation/devicetree/bindings/mfd/axp20x.txt @@ -28,6 +28,20 @@ Required properties: (range: 750-1875). Default: 1.5MHz Optional properties for DCDCs: +- backup: Settings for backup/RTC battery charger + (Voltage in ?V, current in ?A) + If not present, charger will be left untouched +- battery.ocv: OCV capacity curve points (16 data values) +- battery.resistance: internal battery resistance in m? + (defaults to 100m?) +- battery.capacity: Battery capacity in mAh + If this attribute is missing, charger will be disabled + unless there is a battery connected. +- battery.temp_sensor: Description of temperautre sensor, 3 values + - driver current (20?A, 40?A, 60?A or 80?A) + - low temperature warning level (in ?V) + - high temperature warning level (in ?V) + If missing, temperature sensor gets disabled - x-powers,dcdc-workmode: 1 for PWM mode, 0 for AUTO mode Default: AUTO mode @@ -49,6 +63,12 @@ axp209: pmic at 34 { ldo3in-supply = <&axp_ipsout_reg>; ldo5in-supply = <&axp_ipsout_reg>; + backup = <3000000 200>; + battery.ocv = <0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0>; + battery.resistance = <0>; + battery.capacity = <2000>; + battery.temp_sensor = <20 1000000 4000000>; + regulators { x-powers,dcdc-freq = <1500>; -- 2.0.4