From mboxrd@z Thu Jan 1 00:00:00 1970 From: ats@offog.org (Adam Sampson) Date: Tue, 27 Jan 2015 18:25:33 +0000 Subject: [PATCH] ARM: dts: sun7i: Add dts file for pcDuino 3 Nano board In-Reply-To: <20150127170035.GJ7200@lukather> References: <1422199921-325-1-git-send-email-ats@offog.org> <20150125164846.GL8470@lukather> <20150126003520.GA871@cartman.at.offog.org> <20150126100921.GQ8470@lukather> <20150126135931.GB871@cartman.at.offog.org> <20150127170035.GJ7200@lukather> Message-ID: <20150127182533.GE871@cartman.at.offog.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Jan 27, 2015 at 06:00:35PM +0100, Maxime Ripard wrote: > > How about pcduino3-nano:green:usr-led3/4? Or ...:usr1/2, and a comment > > in the .dts explaining how they're labelled on the board? > The latter looks better yes. tx and rx would do too, if you know what > tx and what rx we're talking about here. I've changed it to usr1/2 with comments. (I don't know if they were intended to be TX/RX; the documentation doesn't suggest so.) > > They're multipurpose pins on Arduino-compatible headers: ... > > So should we [...] > None of the above, if there's no hardware default, we won't enforce > any default either. This is a case for the DT overlays. OK -- that simplifies it quite a bit, then. v3 of the patch incoming! Thanks very much, -- Adam Sampson