From mboxrd@z Thu Jan 1 00:00:00 1970 From: boris.brezillon@free-electrons.com (Boris Brezillon) Date: Sun, 8 Feb 2015 21:15:08 +0100 Subject: [PATCH 4/9] mtd: pxa3xx_nand: add a default chunk size In-Reply-To: <1422367816-4257-5-git-send-email-antoine.tenart@free-electrons.com> References: <1422367816-4257-1-git-send-email-antoine.tenart@free-electrons.com> <1422367816-4257-5-git-send-email-antoine.tenart@free-electrons.com> Message-ID: <20150208211508.7b7d2632@bbrezillon> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, 27 Jan 2015 15:10:11 +0100 Antoine Tenart wrote: > Add a default chunk size of 512 in the pxa3xx nand driver. > > Signed-off-by: Antoine Tenart > --- > drivers/mtd/nand/pxa3xx_nand.c | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c > index 782ae24d6b7d..b2783b1f663c 100644 > --- a/drivers/mtd/nand/pxa3xx_nand.c > +++ b/drivers/mtd/nand/pxa3xx_nand.c > @@ -1430,6 +1430,9 @@ static int pxa3xx_nand_scan(struct mtd_info *mtd) > if (pdata->keep_config && !pxa3xx_nand_detect_config(info)) > goto KEEP_CONFIG; > > + /* Set a default chunk size */ Could you explain why you need to set this default chunk size ? I guess it's because your NAND is not configured by the bootloader, and thus you did not specify the keep-config attribute in the DT. And I guess you need this field to be initialized before pxa_ecc_init is called (for some NAND operations done in the meantime: READID ?). Moreover, IMHO this should be place in an 'else' statement, otherwise you'll overwrite the value set in pxa3xx_nand_detect_config. > + info->chunk_size = 512; > + > ret = pxa3xx_nand_sensing(info); > if (ret) { > dev_info(&info->pdev->dev, "There is no chip on cs %d!\n", -- Boris Brezillon, Free Electrons Embedded Linux and Kernel engineering http://free-electrons.com