From mboxrd@z Thu Jan 1 00:00:00 1970 From: kwestfie@codeaurora.org (Kenneth Westfield) Date: Wed, 25 Feb 2015 15:05:01 -0800 Subject: [PATCH] clk: qcom: Properly change rates for ahbix clock In-Reply-To: <1424903527-5636-1-git-send-email-sboyd@codeaurora.org> References: <1424903527-5636-1-git-send-email-sboyd@codeaurora.org> Message-ID: <20150225230500.GA28241@kwestfie-linux.qualcomm.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Feb 25, 2015 at 02:32:07PM -0800, Stephen Boyd wrote: > The ahbix clock can never be turned off. To switch the rates we > need to switch the mux off the M/N counter to an always on source > (XO), reprogram the M/N counter to get the rate we want and > finally switch back to the M/N counter. Add a new ops structure > for this type of clock so that we can set the rate properly. > > Fixes: c99e515a92e9 "clk: qcom: Add IPQ806X LPASS clock controller (LCC) driver" > Cc: Kenneth Westfield > Signed-off-by: Stephen Boyd > --- > drivers/clk/qcom/clk-rcg.c | 30 ++++++++++++++++++++++++++++++ > drivers/clk/qcom/clk-rcg.h | 1 + > drivers/clk/qcom/lcc-ipq806x.c | 5 +---- > 3 files changed, 32 insertions(+), 4 deletions(-) Verified soundcard instantiation on the ipq806x SOC with max98357a codec. Tested-by: Kenneth Westfield -- Kenneth Westfield Qualcomm Innovation Center, Inc. The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project