[PATCHv5 27/35] ARM: dts: am33xx: add minimal l4 bus layout with control module support

[tony@atomide.com (Tony Lindgren)]

* Suman Anna <s-anna@ti.com> [150320 16:24]:
> On 03/20/2015 05:35 PM, Tony Lindgren wrote:
> > * Suman Anna <s-anna@ti.com> [150320 14:44]:
> >> On 03/20/2015 01:44 PM, Kristo, Tero wrote:
> >>> +			scm: scm at 210000 {
> >>> +				compatible = "ti,am3-scm", "simple-bus";
> >>> +				reg = <0x210000 0x2000>;
> >>> +				#address-cells = <1>;
> >>> +				#size-cells = <1>;
> >>> +				ranges = <0 0x210000 0x2000>;
> >>> +
> >>> +				am33xx_pinmux: pinmux at 800 {
> >>> +					compatible = "pinctrl-single";
> >>> +					reg = <0x800 0x238>;
> >>> +					#address-cells = <1>;
> >>> +					#size-cells = <0>;
> >>> +					pinctrl-single,register-width = <32>;
> >>> +					pinctrl-single,function-mask = <0x7f>;
> >>> +				};
> >>> +
> >>> +				scm_conf: scm_conf at 0 {
> >>> +					compatible = "syscon";
> >>> +					reg = <0x0 0x7fc>;
> >>
> >> Hmm, you are consolidating the am33xx_control_module and cm nodes, so is
> >> this supposed to be 0x800 or 0x7fc? I would think it should be 0x800.
> > 
> > Seems correct to me, it's offset 0, size 0x7fc. So that's the scm_conf
> > syscon area before pinctrl-single at 0x44c00000 + 0x210000 + 0.
> > 
> > The io area for pinctrl-single starts at 0x800, so the scm_conf should
> > be before it in the dts file.
> 
> Well, I understand that it is how it was before, but we won't be mapping
> or covering the last register efuse_sma before the pinctrl cfg
> registers. Any reason for just leaving out that register?

Oh I see yeah that looks like a bug to me.

Tony