From mboxrd@z Thu Jan 1 00:00:00 1970 From: olof@lixom.net (Olof Johansson) Date: Fri, 3 Apr 2015 14:56:07 -0700 Subject: [PATCH] ARM: at91/dt: sama5d3 xplained: add phy address for macb1 In-Reply-To: <20150403205507.GH23023@localhost> References: <1427792170-13162-1-git-send-email-nicolas.ferre@atmel.com> <551E52BC.3040702@atmel.com> <20150403205507.GH23023@localhost> Message-ID: <20150403215607.GS23023@localhost> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Apr 03, 2015 at 01:55:07PM -0700, Olof Johansson wrote: > On Fri, Apr 03, 2015 at 10:43:40AM +0200, Nicolas Ferre wrote: > > Le 31/03/2015 10:56, Nicolas Ferre a ?crit : > > > After 57a38effa598 (net: phy: micrel: disable broadcast for KSZ8081/KSZ8091) > > > the macb1 interface refuses to work properly because it tries > > > to cling to address 0 which isn't able to communicate in broadcast with > > > the mac anymore. The micrel phy on the board is actually configured > > > to show up at address 1. > > > Adding the phy node and its real address fixes the issue. > > > > > > Signed-off-by: Nicolas Ferre > > > Cc: Johan Hovold > > > Cc: #3.19 > > > --- > > > > Arnd, Olof, Kevin, > > > > It seems late but, is it possible to queue this patch as a 4.0 fixes? > > > > Without it, the 10/100 Ethernet on sama5d3 doesn't work if it's not used > > by u-boot previously. > > Sure, resend it to arm at kernel.org. Nevermind, I ended up picking it up from the list. Applied. -Olof