[PATCH v5 07/12] mtd: nand: add Samsung K9GBG08U0A-M to nand_ids table

[antoine.tenart@free-electrons.com (Antoine Tenart)]

On Sat, May 16, 2015 at 03:57:00PM -0300, Ezequiel Garcia wrote:
> On 05/11/2015 11:58 AM, Antoine Tenart wrote:
> > Add the full description of the Samsung K9GBG08U0A-M nand chip in the
> > nand_ids table.
> > 
> > Signed-off-by: Antoine Tenart <antoine.tenart@free-electrons.com>
> > ---
> >  drivers/mtd/nand/nand_ids.c | 4 ++++
> >  1 file changed, 4 insertions(+)
> > 
> > diff --git a/drivers/mtd/nand/nand_ids.c b/drivers/mtd/nand/nand_ids.c
> > index dd620c19c619..500c33e1db06 100644
> > --- a/drivers/mtd/nand/nand_ids.c
> > +++ b/drivers/mtd/nand/nand_ids.c
> > @@ -50,6 +50,10 @@ struct nand_flash_dev nand_flash_ids[] = {
> >  		{ .id = {0xad, 0xde, 0x94, 0xda, 0x74, 0xc4} },
> >  		  SZ_8K, SZ_8K, SZ_2M, 0, 6, 640, NAND_ECC_INFO(40, SZ_1K),
> >  		  4 },
> > +	{"NAND 4GiB 3,3V 8-bit",
> > +		{ .id = {0xec, 0xd7, 0x94, 0x76, 0x64, 0x43}, },
> > +		  8192, 4096, SZ_1M, LP_OPTIONS, 0, 0, NAND_ECC_INFO(40, SZ_1K),
> 
> You should stick to SZ_8K and SZ_4K here.

Right.

> 
> > +		  4 },
> >  
> >  	LEGACY_ID_NAND("NAND 4MiB 5V 8-bit",   0x6B, 4, SZ_8K, SP_OPTIONS),
> >  	LEGACY_ID_NAND("NAND 4MiB 3,3V 8-bit", 0xE3, 4, SZ_8K, SP_OPTIONS),
> > 
> 
> I found a datasheet here for K9GBG08U0A that claims to support JEDEC
> device identification (i.e. 0x90 0x40 and 0xEC 0x40 commands). Have you
> tested it? Any reason you are adding full ID instead?

This nand looks like another one defined in this file, so a full ID make
sure the right parameters applies here.

Antoine

-- 
Antoine T?nart, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com