From mboxrd@z Thu Jan 1 00:00:00 1970 From: antoine.tenart@free-electrons.com (Antoine Tenart) Date: Wed, 20 May 2015 16:43:41 +0200 Subject: [PATCH v5 07/12] mtd: nand: add Samsung K9GBG08U0A-M to nand_ids table In-Reply-To: <20150520142409.GP22054@kwain> References: <1431356341-31640-1-git-send-email-antoine.tenart@free-electrons.com> <1431356341-31640-8-git-send-email-antoine.tenart@free-electrons.com> <555792FC.8030407@vanguardiasur.com.ar> <20150520140631.GN22054@kwain> <555C9584.1030609@vanguardiasur.com.ar> <20150520142409.GP22054@kwain> Message-ID: <20150520144341.GQ22054@kwain> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, May 20, 2015 at 04:24:09PM +0200, Antoine Tenart wrote: > On Wed, May 20, 2015 at 11:09:08AM -0300, Ezequiel Garcia wrote: > > On 05/20/2015 11:06 AM, Antoine Tenart wrote: > > > On Sat, May 16, 2015 at 03:57:00PM -0300, Ezequiel Garcia wrote: > > >> On 05/11/2015 11:58 AM, Antoine Tenart wrote: snip. > > >> I found a datasheet here for K9GBG08U0A that claims to support JEDEC > > >> device identification (i.e. 0x90 0x40 and 0xEC 0x40 commands). Have you > > >> tested it? Any reason you are adding full ID instead? > > > > > > This nand looks like another one defined in this file, so a full ID make > > > sure the right parameters applies here. > > > > > > > Oh, so you say the NAND detects the device ID and uses those parameters, > > instead of doing the JEDEC detection? > > I just had a look on the datasheet, and I you're right, the nand should > support JDEC. However I get a "No NAND device found" error when > reverting this patch. > > It seems nand_flash_detect_jedec() is not reading "JDEC" and is returning > directly. I'm having a look at this. So, I can read 'J', 'E', 'D' and 'E' but then I got 0xff's. So I tried to only check of JEDE in nand_flash_detect_jedec() but the JEDEC parameter page was then not valid. Antoine -- Antoine T?nart, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com