From mboxrd@z Thu Jan 1 00:00:00 1970 From: sebastian@breakpoint.cc (Sebastian Andrzej Siewior) Date: Thu, 9 Jul 2015 00:31:56 +0200 Subject: [PATCH v6 4/6] ARM: vf610: enable NAND Flash Controller In-Reply-To: References: <1434668319-6651-1-git-send-email-stefan@agner.ch> <1434668319-6651-5-git-send-email-stefan@agner.ch> <20150708093801.GG28488@tiger> Message-ID: <20150708223156.GA3103@breakpoint.cc> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Jul 08, 2015 at 10:32:54AM -0400, Bill Pringlemeir wrote: > >> diff --git a/arch/arm/mach-imx/Kconfig b/arch/arm/mach-imx/Kconfig > >> index 3a3d3e9..9358135 100644 > >> --- a/arch/arm/mach-imx/Kconfig > >> +++ b/arch/arm/mach-imx/Kconfig > >>>> -589,6 +589,7 @@ config SOC_VF610 > >> select PINCTRL_VF610 > >> select PL310_ERRATA_769419 if CACHE_L2X0 > >> select SMP_ON_UP if SMP > >> + select HAVE_NAND_VF610_NFC > > > I'm not sure about the benefit of having this option, except we have > > to have this additional architecture patch. > > For other SOC, like the PowerPC or ColdFire CPUs with this controller, > it was a way to mark the controller as populated. Otherwise, the > Kconfig entry to select the controller will pop up for everybody. > > Is there a better way to do this? use depends on SOC_VF610 instead. Sebastian