From mboxrd@z Thu Jan 1 00:00:00 1970 From: wsa@the-dreams.de (Wolfram Sang) Date: Fri, 10 Jul 2015 10:11:48 +0200 Subject: [PATCH-v3 02/11] i2c: pxa: No need to set slave addr for i2c master mode reset In-Reply-To: <1436210695-19159-3-git-send-email-vaibhav.hiremath@linaro.org> References: <1436210695-19159-1-git-send-email-vaibhav.hiremath@linaro.org> <1436210695-19159-3-git-send-email-vaibhav.hiremath@linaro.org> Message-ID: <20150710081148.GB1528@katana> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Jul 07, 2015 at 12:54:46AM +0530, Vaibhav Hiremath wrote: > Normally i2c controller works as master, so slave addr is not needed, or it > will impact some slave device (eg. ST NFC chip) i2c accesses, because it has > the same i2c address with controller. Just to make sure: Does it? As I read the code, slave interrupts are enabled later only when slave mode is selected? Is that a HW bug? And if so, can't the code just be moved into this #ifdef block later? > > Signed-off-by: Jett.Zhou > Signed-off-by: Vaibhav Hiremath > Acked-by: Robert Jarzmik > --- > drivers/i2c/busses/i2c-pxa.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/drivers/i2c/busses/i2c-pxa.c b/drivers/i2c/busses/i2c-pxa.c > index f4ac8c5..023e59f 100644 > --- a/drivers/i2c/busses/i2c-pxa.c > +++ b/drivers/i2c/busses/i2c-pxa.c > @@ -459,7 +459,7 @@ static void i2c_pxa_reset(struct pxa_i2c *i2c) > writel(I2C_ISR_INIT, _ISR(i2c)); > writel(readl(_ICR(i2c)) & ~ICR_UR, _ICR(i2c)); > > - if (i2c->reg_isar) > + if (i2c->reg_isar && IS_ENABLED(CONFIG_I2C_PXA_SLAVE)) > writel(i2c->slave_addr, _ISAR(i2c)); > > /* set control register values */ > -- > 1.9.1 > -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: Digital signature URL: