[PATCH v3] ARM: dts: sunxi: Add regulators for LeMaker BananaPi

Timo Sigurdsson
2015-10-07T22:18:36Z

sun7i-a20-bananapi.dts doesn't contain regulator nodes for the AXP209 PMU
driver, so add them to allow for voltage-scaling with cpufreq-dt. Also
add board-specific OPP to use slightly higher voltages at lower
frequencies since Kevin Hilman reported that not all BananaPi boards run
stable at the default voltages inherited by sun7i-a20.dtsi.

Signed-off-by: Timo Sigurdsson <public_timo.s@silentcreek.de>
---
Changes since v2:

- (Re)Added board-specific OPP after Kevin Hilman reported problems with
the default voltages at lower frequencies
---
arch/arm/boot/dts/sun7i-a20-bananapi.dts | 45 +++++++++++++++++++++++++++++---
1 file changed, 41 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/sun7i-a20-bananapi.dts b/arch/arm/boot/dts/sun7i-a20-bananapi.dts
index 9f7b472..39b6b67b 100644
--- a/arch/arm/boot/dts/sun7i-a20-bananapi.dts
+++ b/arch/arm/boot/dts/sun7i-a20-bananapi.dts
@@ -92,6 +92,20 @@
status = "okay";
};

+&cpu0 {
+ cpu-supply = <&reg_dcdc2>;
+ operating-points = <
+ /* kHz uV */
+ 960000 1400000
+ 912000 1400000
+ 864000 1350000
+ 720000 1250000
+ 528000 1150000
+ 312000 1100000
+ 144000 1050000
+ >;
+};
+
&ehci0 {
status = "okay";
};
@@ -119,13 +133,9 @@
status = "okay";

axp209: pmic at 34 {
- compatible = "x-powers,axp209";
reg = <0x34>;
interrupt-parent = <&nmi_intc>;
interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
-
- interrupt-controller;
- #interrupt-cells = <1>;
};
};

@@ -182,6 +192,33 @@
};
};

+#include "axp209.dtsi"
+
+&reg_dcdc2 {
+ regulator-always-on;
+ regulator-min-microvolt = <1000000>;
+ regulator-max-microvolt = <1400000>;
+ regulator-name = "vdd-cpu";
+};
+
+&reg_dcdc3 {
+ regulator-always-on;
+ regulator-min-microvolt = <1000000>;
+ regulator-max-microvolt = <1400000>;
+ regulator-name = "vdd-int-dll";
+};
+
+&reg_ldo1 {
+ regulator-name = "vdd-rtc";
+};
+
+&reg_ldo2 {
+ regulator-always-on;
+ regulator-min-microvolt = <3000000>;
+ regulator-max-microvolt = <3000000>;
+ regulator-name = "avcc";
+};
+
&reg_usb1_vbus {
status = "okay";
};
--
2.1.4