From mboxrd@z Thu Jan 1 00:00:00 1970 From: linux@arm.linux.org.uk (Russell King - ARM Linux) Date: Thu, 5 Nov 2015 09:27:04 +0000 Subject: [PATCH 11/11] tty: amba-pl011: add support for ZTE UART (EXPERIMENTAL) In-Reply-To: References: <20151103134349.GV8644@n2100.arm.linux.org.uk> Message-ID: <20151105092703.GN8644@n2100.arm.linux.org.uk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Thu, Nov 05, 2015 at 09:28:23AM +0100, Linus Walleij wrote: > On Tue, Nov 3, 2015 at 3:51 PM, Russell King > wrote: > > > Add (incomplete) support for the ZTE UART to the AMBA PL011 driver. > > This is similar to the ARM and ST variants, except it has a different > > register address layout, and requires 32-bit accesses to the registers. > > Use the newly introduced register tables and access size support to > > cope with these differences. > > > > Signed-off-by: Russell King > > I applied the whole series, 1-11 and tested on Ux500 (ST Micro variant) > and on the ARM RealView PB11MPCore. > > It works like a charm. I also like the looks of this transformation. > Tested-by: Linus Walleij As I mentioned, the change in pl011_putc() needs undoing (I've already modified that in my series). Also, I'll try switching to the relaxed accessors and checking that. Thanks for the tested-by though, can I assume that you're happy I add that even with the pl011_putc() change undone? -- FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up according to speedtest.net.