[PATCH v10 3/4] irqchip:create irq domain for each mbigen device

[mark.rutland@arm.com (Mark Rutland)]

On Thu, Dec 17, 2015 at 07:56:36PM +0800, MaJun wrote:
> From: Ma Jun <majun258@huawei.com>
> 
> For peripheral devices which connect to mbigen,mbigen is a interrupt
> controller. So, we create irq domain for each mbigen device and add
> mbigen irq domain into irq hierarchy structure.
> 
> Signed-off-by: Ma Jun <majun258@huawei.com>
> ---
>  drivers/irqchip/irq-mbigen.c |  138 ++++++++++++++++++++++++++++++++++++++++++
>  1 files changed, 138 insertions(+), 0 deletions(-)

[...]

> +static int mbigen_domain_translate(struct irq_domain *d,
> +				    struct irq_fwspec *fwspec,
> +				    unsigned long *hwirq,
> +				    unsigned int *type)
> +{
> +	if (is_of_node(fwspec->fwnode)) {
> +		if (fwspec->param_count != 2)
> +			return -EINVAL;
> +
> +		if ((fwspec->param[0] > MAXIMUM_IRQ_PIN_NUM) ||
> +			(fwspec->param[0] < RESERVED_IRQ_PER_MBIGEN_CHIP))
> +			return -EINVAL;
> +		else
> +			*hwirq = fwspec->param[0];
> +
> +		/* If there is no valid irq type, just use the default type */
> +		if ((fwspec->param[1] == IRQ_TYPE_EDGE_RISING) ||
> +			(fwspec->param[1] == IRQ_TYPE_LEVEL_HIGH))
> +			*type = fwspec->param[1];
> +		else
> +			*type = IRQ_TYPE_NONE;

That does not seem like a good idea. The binding requires one of two
types, and the DT is clearly wrong in the else case. 

I think for the else case we should return -EINVAL.

Thanks,
Mark.