From mboxrd@z Thu Jan 1 00:00:00 1970 From: linux@arm.linux.org.uk (Russell King - ARM Linux) Date: Fri, 8 Jan 2016 22:50:32 +0000 Subject: bcm4708-smartrg-sr400ac boot failures in next/arm-soc In-Reply-To: References: Message-ID: <20160108225032.GO19062@n2100.arm.linux.org.uk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Jan 08, 2016 at 02:33:39PM -0800, Tyler Baker wrote: > After a bit of investigation, I determined that CONFIG_BLK_DEV_RAM was > causing the issue and disabling it fixed the boot issue. Essentially, > the kernel cannot find the initrd that has been loaded into memory by > CFE bootloader with this option enabled as I inject the following > command line into the DT before it's loaded over tftp. > > Loaded in CFE by: 'load -raw -tftp -addr=0x4000000 -max=0x900000 > 192.168.2.2:tmpqC9zOv/ramdisk.cpio.gz' > > Kernel arguments injected into DT: 'console=ttyS0,115200 > initrd=0x4000000,8M root=/dev/ram0 ip=dhcp' What is the problem that the kernel is reporting? I'm asking because kernelci.org uses javascript, which is not elinks friendly, and it otherwise means I need to walk over to a different machine to look at it, and then return to a different machine to finish writing the email - as a result, I hardly ever look at the kernelci.org results, and just rely on Olof's results. -- RMK's Patch system: http://www.arm.linux.org.uk/developer/patches/ FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up according to speedtest.net.