From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@free-electrons.com (Maxime Ripard) Date: Mon, 7 Mar 2016 21:30:24 +0100 Subject: [PATCH] dma: sun4i: expose block size and wait cycle configuration to DMA users In-Reply-To: <20160307160857.577bb04d@bbrezillon> References: <1457344771-12946-1-git-send-email-boris.brezillon@free-electrons.com> <20160307145429.GG11154@localhost> <20160307160857.577bb04d@bbrezillon> Message-ID: <20160307203024.GD8418@lukather> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Mon, Mar 07, 2016 at 04:08:57PM +0100, Boris Brezillon wrote: > Hi Vinod, > > On Mon, 7 Mar 2016 20:24:29 +0530 > Vinod Koul wrote: > > > On Mon, Mar 07, 2016 at 10:59:31AM +0100, Boris Brezillon wrote: > > > +/* Dedicated DMA parameter register layout */ > > > +#define SUN4I_DDMA_PARA_DST_DATA_BLK_SIZE(n) (((n) - 1) << 24) > > > +#define SUN4I_DDMA_PARA_DST_WAIT_CYCLES(n) (((n) - 1) << 16) > > > +#define SUN4I_DDMA_PARA_SRC_DATA_BLK_SIZE(n) (((n) - 1) << 8) > > > +#define SUN4I_DDMA_PARA_SRC_WAIT_CYCLES(n) (((n) - 1) << 0) > > > + > > > +/** > > > + * struct sun4i_dma_chan_config - DMA channel config > > > + * > > > + * @para: contains information about block size and time before checking > > > + * DRQ line. This is device specific and only applicable to dedicated > > > + * DMA channels > > > > What information, can you elobrate.. And why can't you use existing > > dma_slave_config for this? > > Block size is related to the device FIFO size. I guess it allows the > DMA channel to launch a transfer of X bytes without having to check the > DRQ line (the line telling the DMA engine it can transfer more data > to/from the device). The wait cycles information is apparently related > to the number of clks the engine should wait before polling/checking > the DRQ line status between each block transfer. I'm not sure what it > saves to put WAIT_CYCLES() to something != 1, but in their BSP, > Allwinner tweak that depending on the device. > > Note that I'd be happy if the above configuration could go into the > generic dma_slave_config struct. This way we could avoid per-engine > specific APIs. And I'd really like to avoid that too. That will avoid to cripple the consumer drivers that might be using any of the two. Thanks! Maxime -- Maxime Ripard, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: Digital signature URL: