[PATCH v2 2/9] ARM: dts: imx7d: add flexcan support

[shawnguo@kernel.org (Shawn Guo)]

On Tue, Mar 15, 2016 at 03:04:21PM +0100, Gary Bisson wrote:
> Add the device nodes for the i.MX7 FlexCAN buses.
> 
> Signed-off-by: Gary Bisson <gary.bisson@boundarydevices.com>
> ---
> 
> Changelog v1 -> v2:
> - none
> 
> ---
>  arch/arm/boot/dts/imx7d.dtsi | 22 ++++++++++++++++++++++
>  1 file changed, 22 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/imx7d.dtsi b/arch/arm/boot/dts/imx7d.dtsi
> index a768716..c5e47a4 100644
> --- a/arch/arm/boot/dts/imx7d.dtsi
> +++ b/arch/arm/boot/dts/imx7d.dtsi
> @@ -930,6 +930,28 @@
>  				fsl,num-rx-queues=<3>;
>  				status = "disabled";
>  			};
> +
> +			flexcan1: can at 30a00000 {
> +				compatible = "fsl,imx7d-flexcan", "fsl,imx6q-flexcan";
> +				reg = <0x30a00000 0x10000>;
> +				interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_HIGH>;
> +				clocks = <&clks IMX7D_CLK_DUMMY>,
> +					<&clks IMX7D_CAN1_ROOT_CLK>;
> +				clock-names = "ipg", "per";
> +				stop-mode = <&gpr 0x10 1 0x10 17>;

Is this property documented anywhere, or even supported by mainline
kernel?

Shawn

> +				status = "disabled";
> +			};
> +
> +			flexcan2: can at 30a10000 {
> +				compatible = "fsl,imx7d-flexcan", "fsl,imx6q-flexcan";
> +				reg = <0x30a10000 0x10000>;
> +				interrupts = <GIC_SPI 111 IRQ_TYPE_LEVEL_HIGH>;
> +				clocks = <&clks IMX7D_CLK_DUMMY>,
> +					<&clks IMX7D_CAN2_ROOT_CLK>;
> +				clock-names = "ipg", "per";
> +				stop-mode = <&gpr 0x10 2 0x10 18>;
> +				status = "disabled";
> +			};
>  		};
>  	};
>  };
> -- 
> 2.7.0
> 
>