[PATCH 13/23] mmc: sdhci-esdhc-imx: restore watermark level setting after resume

[dongas86@gmail.com (Dong Aisheng)]

On Tue, May 10, 2016 at 12:30:16PM +0300, Adrian Hunter wrote:
> On 15/04/16 20:29, Dong Aisheng wrote:
> > Currently, we config the watermark_level register only in probe.
> > This will cause the mmc write operation timeout issue after system
> > resume back in LPSR mode. Because in LPSR mode, after system resume
> > back, the watermark_level register(0x44) changes to 0x08000880, which
> > set the write watermark level as 0, and set the read watermark level
> > as 128. This value is incorrect.
> > 
> > This patch restores the setting of watermark level register after
> > system resume back.
> 
> In sdhci_esdhc_imx_probe() the watermark setting is conditional on
> esdhc_is_usdhc(imx_data), but in the resume it is not.  Is that intended?
> If so, maybe explain that in the commit message.
> 

Good catch!
I think we'd probably better keep that condition check.
Will update it in V2.


> Might be worth pulling out the constant 0x10401040 and #defining it since it
> is used in more than one place too.
> 

Good point!
Will do it.

Regards
Dong Aisheng

> > 
> > Signed-off-by: Dong Aisheng <aisheng.dong@nxp.com>
> > ---
> >  drivers/mmc/host/sdhci-esdhc-imx.c | 5 +++++
> >  1 file changed, 5 insertions(+)
> > 
> > diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
> > index 6fef6bc..4c28fbb 100644
> > --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> > +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> > @@ -1261,6 +1261,11 @@ static int sdhci_esdhc_suspend(struct device *dev)
> >  
> >  static int sdhci_esdhc_resume(struct device *dev)
> >  {
> > +	struct sdhci_host *host = dev_get_drvdata(dev);
> > +
> > +	/* restore watermark setting in case it's lost in low power mode */
> > +	writel(0x10401040, host->ioaddr + ESDHC_WTMK_LVL);
> > +
> >  	return sdhci_pltfm_resume(dev);
> >  }
> >  
> > 
>