[PATCH 2/3] mmc: sunxi: Set the 'New Timing' register for 8 bits DDR transfers

[maxime.ripard@free-electrons.com (Maxime Ripard)]

On Thu, Jul 21, 2016 at 11:26:55AM +0200, Jean-Francois Moine wrote:
> On Thu, 21 Jul 2016 10:56:15 +0200
> Maxime Ripard <maxime.ripard@free-electrons.com> wrote:
> 
> > On Wed, Jul 20, 2016 at 08:16:28PM +0200, Jean-Francois Moine wrote:
> > > The 'new timing mode' with 8 bits DDR works correctly when the NewTiming
> > > register is set.
> > 
> > What does that mode brings to the table?
> 
> From my tests, the eMMC of the Banana Pi M3 (A83T) cannot work when the
> new mode is not used.
> 
> > > 
> > > Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
> > > ---
> > > Note about the 'new timing mode'.
> > > 
> > > This patch assumes that, when the new mode is used, the clock driver
> > > sets the mode select in the MMC clock and multiplies the clock rate
> > > by 2:
> > > - MMC side:
> > >   - with a timing 8 bits DDR at 50MHz, the MMC driver calls
> > >     clk_set_rate() with a rate 50*2 = 100MHz,
> > > - clock side:
> > >   - the clock driver sets the hardware MMC clock to 100*2 = 200MHz,
> > >   - setting the 'mode select' of the hardware MMC clock divides the
> > >     rate by 2,
> > > - MMC side:
> > >   - setting the MMC clock divider register to 1 divides the rate by 2.
> > > So, the final rate is 50MHz.
> > 
> > What happens if you actually want to set it to 100MHz?
> 
> There is no SDXC_CLK_100M in the mainline driver, and 100MHz is asked
> only for 8 bits DDR at 50MHz.

You're missing the point.

clk_set_rate is supposed to apply a rate as close as possible as
requested, there's no reason why you would request a rate twice as
high as need.

You want to switch the clock from one mode to another, fine, create a
new function for that. But don't hack an existing one.

Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 819 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20160729/9761ce2a/attachment.sig>