From mboxrd@z Thu Jan  1 00:00:00 1970
From: davem@davemloft.net (David Miller)
Date: Fri, 12 Aug 2016 16:57:53 -0700 (PDT)
Subject: [PATCH v6 0/3] net: phy: Add xilinx gmiitorgmii converter support
In-Reply-To: <1470808208-32133-1-git-send-email-appanad@xilinx.com>
References: <1470808208-32133-1-git-send-email-appanad@xilinx.com>
Message-ID: <20160812.165753.1652467337612232120.davem@davemloft.net>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

From: Kedareswara rao Appana <appana.durga.rao@xilinx.com>
Date: Wed, 10 Aug 2016 11:20:05 +0530

> The Gigabit Media Independent Interface (GMII) to Reduced Gigabit Media
> Independent Interface (RGMII) core provides the RGMII between RGMII-compliant
> Ethernet physical media devices (PHY) and the Gigabit Ethernet controller.
> This core can be used in all three modes of operation(10/100/1000 Mb/s).
> The Management Data Input/Output (MDIO) interface is used to configure the
> Speed of operation. This core can switch dynamically between the three
> Different speed modes by configuring the conveter register through mdio write.
> 
> The conveter sits b/w the MAC and external phy like below
> 
> MACB <==> GMII2RGMII <==> RGMII_PHY
> 
>         MDIO    <========> GMII2RGMII
> MCAB <=======>
>                 <========> RGMII
> 
> Using MAC MDIO bus we can access both the converter and the external PHY.
> We need to program the line speed of the converter during run time based
> On the external phy negotiated speed.
> 
> This patch series does the below
> ---> Add mask for Control register 10Mbps speed.
> ---> Add support for xilinx gmiitorgmii converter.

Series applied, thanks.