From mboxrd@z Thu Jan 1 00:00:00 1970 From: martin.blumenstingl@googlemail.com (Martin Blumenstingl) Date: Sun, 4 Sep 2016 23:31:51 +0200 Subject: [PATCH 6/7] ARM64: meson-gxbb-p20x: Enable USB Nodes In-Reply-To: <20160904213152.25837-1-martin.blumenstingl@googlemail.com> References: <20160904213152.25837-1-martin.blumenstingl@googlemail.com> Message-ID: <20160904213152.25837-7-martin.blumenstingl@googlemail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org From: Jerome Brunet Enable both gxbb USB controller and add a 5V regulator for the OTG port VBUS Signed-off-by: Jerome Brunet Signed-off-by: Martin Blumenstingl --- arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi | 29 ++++++++++++++++++++++++ 1 file changed, 29 insertions(+) diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi index ce105fe..4493bce 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi @@ -93,6 +93,18 @@ compatible = "mmc-pwrseq-emmc"; reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>; }; + + usb_vbus: regulator-usb0-vbus { + compatible = "regulator-fixed"; + + regulator-name = "USB0_VBUS"; + + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + + gpio = <&gpio GPIODV_24 GPIO_ACTIVE_HIGH>; + enable-active-high; + }; }; /* This UART is brought out to the DB9 connector */ @@ -149,3 +161,20 @@ vmmc-supply = <&vcc_3v3>; vmmcq-sumpply = <&vddio_boot>; }; + +&usb0_phy { + status = "okay"; + phy-supply = <&usb_vbus>; +}; + +&usb1_phy { + status = "okay"; +}; + +&usb0 { + status = "okay"; +}; + +&usb1 { + status = "okay"; +}; -- 2.9.3