From mboxrd@z Thu Jan 1 00:00:00 1970 From: krzk@kernel.org (Krzysztof Kozlowski) Date: Sun, 18 Sep 2016 21:23:14 +0200 Subject: [PATCH v7 2/3] ARM: dts: add TOPEET itop elite based board In-Reply-To: <1474207279-9662-3-git-send-email-ayaka@soulik.info> References: <1474207279-9662-1-git-send-email-ayaka@soulik.info> <1474207279-9662-3-git-send-email-ayaka@soulik.info> Message-ID: <20160918192314.GA6676@kozik-book> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Sun, Sep 18, 2016 at 10:01:18PM +0800, Randy Li wrote: > The TOPEET itop exynos 4412 have three versions base board. The > Elite version is the cheap one without too much peripheral devices > on it. > > Currently supported are serial console, wired networking(USB), > USB OTG in peripheral mode, USB host, SD storage, GPIO buttons, > PWM beeper, ADC and LEDs. The WM8960 analog audio codec is also > enabled. > > The FIMC is not used for camera currently, I enabled it just for a > colorspace convertor. > > Signed-off-by: Randy Li > --- > .../bindings/arm/samsung/samsung-boards.txt | 3 + > arch/arm/boot/dts/Makefile | 1 + > arch/arm/boot/dts/exynos4412-itop-elite.dts | 240 +++++++++++++++++++++ > 3 files changed, 244 insertions(+) > create mode 100644 arch/arm/boot/dts/exynos4412-itop-elite.dts Looks good to me, for the record: Reviewed-by: Krzysztof Kozlowski You don't need to resend the third patch. Rob took it. Best regards, Krzysztof