From mboxrd@z Thu Jan 1 00:00:00 1970 From: bjorn.andersson@linaro.org (Bjorn Andersson) Date: Thu, 3 Nov 2016 14:53:08 -0700 Subject: [PATCH 2/3] ARM: dts: reference PM8058 as IRQ parent In-Reply-To: <1478164390-21613-2-git-send-email-linus.walleij@linaro.org> References: <1478164390-21613-1-git-send-email-linus.walleij@linaro.org> <1478164390-21613-2-git-send-email-linus.walleij@linaro.org> Message-ID: <20161103215308.GU25787@tuxbot> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Thu 03 Nov 02:13 PDT 2016, Linus Walleij wrote: > Some nodes are referencing the pm8058_gpio as IRQ parent, but > the HW IRQ offset they are supplying is actually that for the > parent to that controller: the PM8058 itself. Since that is the > proper parent, reference it directly. > > We can switch this to the pm8058_gpio and the proper offset > once we have fixed the SSBI GPIO driver to properly deal with > the hierarchical IRQ domain and get proper local offset > translation. > > Signed-off-by: Linus Walleij Acked-by: Bjorn Andersson Regards, Bjorn > --- > arch/arm/boot/dts/qcom-apq8060-dragonboard.dts | 8 ++++---- > 1 file changed, 4 insertions(+), 4 deletions(-) > > diff --git a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts > index 4a532ddab53a..ea660ffa03ea 100644 > --- a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts > +++ b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts > @@ -369,8 +369,8 @@ > ak8975 at 0c { > compatible = "asahi-kasei,ak8975"; > reg = <0x0c>; > - /* GPIO33 has interrupt 224 on the PM8058 */ > - interrupt-parent = <&pm8058_gpio>; > + /* FIXME: GPIO33 has interrupt 224 on the PM8058 */ > + interrupt-parent = <&pm8058>; > interrupts = <224 IRQ_TYPE_EDGE_RISING>; > pinctrl-names = "default"; > pinctrl-0 = <&dragon_ak8975_gpios>; > @@ -380,8 +380,8 @@ > bmp085 at 77 { > compatible = "bosch,bmp085"; > reg = <0x77>; > - /* GPIO16 has interrupt 207 on the PM8058 */ > - interrupt-parent = <&pm8058_gpio>; > + /* FIXME: GPIO16 has interrupt 207 on the PM8058 */ > + interrupt-parent = <&pm8058>; > interrupts = <207 IRQ_TYPE_EDGE_RISING>; > reset-gpios = <&tlmm 86 GPIO_ACTIVE_LOW>; > pinctrl-names = "default"; > -- > 2.7.4 >