From mboxrd@z Thu Jan 1 00:00:00 1970 From: wens@csie.org (Chen-Yu Tsai) Date: Thu, 24 Nov 2016 19:29:08 +0800 Subject: [PATCH] ARM: dts: sun6i: hummingbird: Enable USB OTG Message-ID: <20161124112908.4796-1-wens@csie.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The A31 Hummingbird has a mini USB OTG port, and uses GPIO pins from the SoC for ID pin and VBUS detection and VBUS control. The PMIC can also do VBUS detection and control. Here we prefer to use the PMIC's DRIVEVBUS function to control VBUS for USB OTG, as that is the hardware default. Signed-off-by: Chen-Yu Tsai --- arch/arm/boot/dts/sun6i-a31-hummingbird.dts | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+) diff --git a/arch/arm/boot/dts/sun6i-a31-hummingbird.dts b/arch/arm/boot/dts/sun6i-a31-hummingbird.dts index 83643bbd51dc..f094eeb6c499 100644 --- a/arch/arm/boot/dts/sun6i-a31-hummingbird.dts +++ b/arch/arm/boot/dts/sun6i-a31-hummingbird.dts @@ -248,6 +248,7 @@ reg = <0x68>; interrupt-parent = <&nmi_intc>; interrupts = <0 IRQ_TYPE_LEVEL_LOW>; + x-powers,drive-vbus-en; }; }; @@ -306,6 +307,11 @@ regulator-name = "vcc-dram"; }; +®_drivevbus { + regulator-name = "usb0-vbus"; + status = "okay"; +}; + ®_usb1_vbus { gpio = <&pio 7 24 GPIO_ACTIVE_HIGH>; /* PH24 */ status = "okay"; @@ -330,12 +336,25 @@ status = "okay"; }; +&usb_otg { + dr_mode = "otg"; + status = "okay"; +}; + +&usb_power_supply { + status = "okay"; +}; + &usb1_vbus_pin_a { /* different pin from sunxi-common-regulators */ pins = "PH24"; }; &usbphy { + usb0_id_det-gpio = <&pio 0 15 GPIO_ACTIVE_HIGH>; /* PA15 */ + usb0_vbus_det-gpio = <&pio 0 16 GPIO_ACTIVE_HIGH>; /* PA16 */ + usb0_vbus_power-supply = <&usb_power_supply>; + usb0_vbus-supply = <®_drivevbus>; usb1_vbus-supply = <®_usb1_vbus>; status = "okay"; }; -- 2.10.2