From mboxrd@z Thu Jan 1 00:00:00 1970 From: robh@kernel.org (Rob Herring) Date: Mon, 12 Dec 2016 12:59:43 -0600 Subject: [PATCH v6 7/8] ARM: dts: stm32: add Timers driver for stm32f429 MCU In-Reply-To: <1481292919-26587-8-git-send-email-benjamin.gaignard@st.com> References: <1481292919-26587-1-git-send-email-benjamin.gaignard@st.com> <1481292919-26587-8-git-send-email-benjamin.gaignard@st.com> Message-ID: <20161212185943.ph7njaqb2lxtgdn4@rob-hp-laptop> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Dec 09, 2016 at 03:15:18PM +0100, Benjamin Gaignard wrote: > Add Timers and it sub-nodes into DT for stm32f429 family. > > version 6: > - split patch in two: one for SoC family and one for stm32f469 > discovery board. > > version 5: > - rename gptimer node to timers > - re-order timers node par addresses > > version 4: > - remove unwanted indexing in pwm@ and timer@ node name > - use "reg" instead of additional parameters to set timer > configuration > > version 3: > - use "st,stm32-timer-trigger" in DT > > version 2: > - use parameters to describe hardware capabilities > - do not use references for pwm and iio timer subnodes > > Signed-off-by: Benjamin Gaignard > --- > arch/arm/boot/dts/stm32f429.dtsi | 275 +++++++++++++++++++++++++++++++++++++++ > 1 file changed, 275 insertions(+) > > diff --git a/arch/arm/boot/dts/stm32f429.dtsi b/arch/arm/boot/dts/stm32f429.dtsi > index bca491d..d0fb9cc 100644 > --- a/arch/arm/boot/dts/stm32f429.dtsi > +++ b/arch/arm/boot/dts/stm32f429.dtsi > @@ -355,6 +355,21 @@ > slew-rate = <2>; > }; > }; > + > + pwm1_pins: pwm at 1 { No reg prop, so should not have a unit-address. Given the names in the define below, seems like "timer1" would be appropriate. > + pins { > + pinmux = , > + , > + ; > + }; > + }; > + > + pwm3_pins: pwm at 3 { > + pins { > + pinmux = , > + ; > + }; > + }; > }; > > rcc: rcc at 40023810 { > @@ -426,6 +441,266 @@ > interrupts = <80>; > clocks = <&rcc 0 38>; > }; > + > + timers2: timers at 40000000 { timer at ... It may be more than just a timer, there's not a better generic name. > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40000000 0x400>; > + clocks = <&rcc 0 128>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <1>; > + status = "disabled"; > + }; > + }; > + > + timers3: timers at 40000400 { ditto > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40000400 0x400>; > + clocks = <&rcc 0 129>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <2>; > + status = "disabled"; > + }; > + }; > + > + timers4: timers at 40000800 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40000800 0x400>; > + clocks = <&rcc 0 130>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <3>; > + status = "disabled"; > + }; > + }; > + > + timers5: timers at 40000C00 { timer at ... And use lowercase hex. > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40000C00 0x400>; ditto > + clocks = <&rcc 0 131>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <4>; > + status = "disabled"; > + }; > + }; > + > + timers6: timers at 40001000 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40001000 0x400>; > + clocks = <&rcc 0 132>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <5>; > + status = "disabled"; > + }; > + }; > + > + timers7: timers at 40001400 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40001400 0x400>; > + clocks = <&rcc 0 133>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <6>; > + status = "disabled"; > + }; > + }; > + > + timers12: timers at 40001800 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40001800 0x400>; > + clocks = <&rcc 0 134>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <9>; > + status = "disabled"; > + }; > + }; > + > + timers13: timers at 40001C00 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40001C00 0x400>; > + clocks = <&rcc 0 135>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + }; > + > + timers14: timers at 40002000 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40002000 0x400>; > + clocks = <&rcc 0 136>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + }; > + > + timers1: timers at 40010000 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40010000 0x400>; > + clocks = <&rcc 0 160>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <0>; > + status = "disabled"; > + }; > + }; > + > + timers8: timers at 40010400 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40010400 0x400>; > + clocks = <&rcc 0 161>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <7>; > + status = "disabled"; > + }; > + }; > + > + timers9: timers at 40014000 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40014000 0x400>; > + clocks = <&rcc 0 176>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + > + timer { > + compatible = "st,stm32-timer-trigger"; > + reg = <8>; > + status = "disabled"; > + }; > + }; > + > + timers10: timers at 40014400 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40014400 0x400>; > + clocks = <&rcc 0 177>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + }; > + > + timers11: timers at 40014800 { > + #address-cells = <1>; > + #size-cells = <0>; > + compatible = "st,stm32-timers"; > + reg = <0x40014800 0x400>; > + clocks = <&rcc 0 178>; > + clock-names = "clk_int"; > + status = "disabled"; > + > + pwm { > + compatible = "st,stm32-pwm"; > + status = "disabled"; > + }; > + }; > }; > }; > > -- > 1.9.1 >