From mboxrd@z Thu Jan 1 00:00:00 1970 From: hzpeterchen@gmail.com (Peter Chen) Date: Tue, 3 Jan 2017 14:53:19 +0800 Subject: [PATCH v6 23/25] usb: chipidea: Pullup D+ in device mode via phy APIs In-Reply-To: <20161228225711.698-24-stephen.boyd@linaro.org> References: <20161228225711.698-1-stephen.boyd@linaro.org> <20161228225711.698-24-stephen.boyd@linaro.org> Message-ID: <20170103065318.GB14542@b29397-desktop> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wed, Dec 28, 2016 at 02:57:09PM -0800, Stephen Boyd wrote: > If the phy supports it, call phy_set_mode() to pull up D+ when > required by setting the mode to PHY_MODE_USB_DEVICE. If we want > to remove the pullup, set the mode to PHY_MODE_USB_HOST. > > Cc: Peter Chen > Cc: Greg Kroah-Hartman > Signed-off-by: Stephen Boyd > --- > drivers/usb/chipidea/udc.c | 10 ++++++++-- > 1 file changed, 8 insertions(+), 2 deletions(-) > > diff --git a/drivers/usb/chipidea/udc.c b/drivers/usb/chipidea/udc.c > index 0d532a724d48..6d61fa0689b0 100644 > --- a/drivers/usb/chipidea/udc.c > +++ b/drivers/usb/chipidea/udc.c > @@ -18,6 +18,7 @@ > #include > #include > #include > +#include > #include > #include > #include > @@ -1609,10 +1610,15 @@ static int ci_udc_pullup(struct usb_gadget *_gadget, int is_on) > return 0; > > pm_runtime_get_sync(&ci->gadget.dev); > - if (is_on) > + if (is_on) { > + if (ci->phy) > + phy_set_mode(ci->phy, PHY_MODE_USB_DEVICE); > hw_write(ci, OP_USBCMD, USBCMD_RS, USBCMD_RS); > - else > + } else { > hw_write(ci, OP_USBCMD, USBCMD_RS, 0); > + if (ci->phy) > + phy_set_mode(ci->phy, PHY_MODE_USB_HOST); > + } > pm_runtime_put_sync(&ci->gadget.dev); > > return 0; > -- Would you describe the use case for it? Why not adding it at role switch routine? -- Best Regards, Peter Chen