From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@free-electrons.com (Maxime Ripard) Date: Mon, 23 Jan 2017 11:58:42 +0100 Subject: [PATCH v3 0/13] arm64: allwinner: a64: Enable MMC support In-Reply-To: References: Message-ID: <20170123105842.37q23ecxecrjr6so@lukather> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Ulf, On Mon, Jan 16, 2017 at 05:56:50PM +0100, Maxime Ripard wrote: > Hi, > > Here is a new attempt at getting the MMC controllers running, following the > work done by Andre. > > This has been tested on a board with one SDIO device (a Marvell WiFi chip) > and a Kingston eMMC with 1.8V IOs. > > For SDIO, the HS DDR mode works just fine. That serie also enables the > SDR104 mode to work on the devices that are capable of this. > > For the eMMC, HS200 with the voltage switch works. HS400 doesn't at the > moment, but since it's significantly more complex, and at the same time > Allwinner recommends to limit its frequency to 100MHz, this doesn't have > any benefits. If there's any at some point, this can be added later. Unless you have objections, I'd really like this to be in 4.11. There's a bunch of things where I'm not entirely sure (especially the clock gating part), it would be great if you could have a look. Thanks! Maxime -- Maxime Ripard, Free Electrons Embedded Linux and Kernel engineering http://free-electrons.com -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 801 bytes Desc: not available URL: