From mboxrd@z Thu Jan 1 00:00:00 1970 From: codekipper@gmail.com (codekipper at gmail.com) Date: Fri, 27 Jan 2017 16:48:08 +0100 Subject: [linux-sunxi][PATCH 3/3] ARM: dts: sun8i-h3: Add SPDIF to the Beelink X2 In-Reply-To: <20170127154808.19229-1-codekipper@gmail.com> References: <20170127154808.19229-1-codekipper@gmail.com> Message-ID: <20170127154808.19229-4-codekipper@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org From: Marcus Cooper Enable the S/PDIF transmitter that is present on the Beelink X2 STB. Signed-off-by: Marcus Cooper --- arch/arm/boot/dts/sun8i-h3-beelink-x2.dts | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+) diff --git a/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts b/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts index 2a016cd16a27..25b225b7dfd6 100644 --- a/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts +++ b/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts @@ -81,6 +81,24 @@ compatible = "mmc-pwrseq-simple"; reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */ }; + + sound_spdif { + compatible = "simple-audio-card"; + simple-audio-card,name = "On-board SPDIF"; + + simple-audio-card,cpu { + sound-dai = <&spdif>; + }; + + simple-audio-card,codec { + sound-dai = <&spdif_out>; + }; + }; + + spdif_out: spdif-out { + #sound-dai-cells = <0>; + compatible = "linux,spdif-dit"; + }; }; &ehci1 { @@ -124,6 +142,12 @@ status = "okay"; }; +&spdif { + pinctrl-names = "default"; + pinctrl-0 = <&spdif_tx_pins_a>; + status = "okay"; +}; + &uart0 { pinctrl-names = "default"; pinctrl-0 = <&uart0_pins_a>; -- 2.11.0