From mboxrd@z Thu Jan 1 00:00:00 1970 From: w@1wt.eu (Willy Tarreau) Date: Sun, 12 Feb 2017 01:53:50 +0100 Subject: [PATCH] ARM: dts: armada-385-synology-ds116: add support for Synology DS116 NAS In-Reply-To: <20170212004031.GA7328@lunn.ch> References: <1486805073-15534-1-git-send-email-w@1wt.eu> <20170212004031.GA7328@lunn.ch> Message-ID: <20170212005350.GA18612@1wt.eu> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Andrew, On Sun, Feb 12, 2017 at 01:40:31AM +0100, Andrew Lunn wrote: > > + serial at 12000 { > > + pinctrl-names = "default"; > > + pinctrl-0 = <&uart0_pins>; > > + status = "okay"; > > + }; > > + > > + serial at 12100 { > > + /* A PIC16F1829 is connected to uart1 at 115200 bps, > > + * and takes single-character orders : > > + * "1" : power off > > Hi Willy > > The qnap-poweroff.c driver will support this. You need a new > compatible string, since 115200 is not the speed the current synology > devices use. But won't that squat the I/O address and prevent me from using all the other codes via the regular serial port ? They are particularly convenient in fact since they are the only way to access the LEDs, beeper and even to trigger a reset (even if this last one is less used in software form). > > + * "2" : short beep > > + * "3" : long beep > > + * "4" : turn the power LED ON > > + * "5" : flash the power LED > > + * "6" : turn the power LED OFF > > + * "7" : turn the status LED OFF > > + * "8" : turn the status LED ON > > + * "9" : flash the status LED > > + * "A" : flash the motherboard LED (D8) > > + * "B" : turn the motherboard LED OFF > > + * "C" : hard reset > > + */ > > + pinctrl-names = "default"; > > + pinctrl-0 = <&uart1_pins>; > > + status = "okay"; > > + }; > > > + gpio-leds { > > + compatible = "gpio-leds"; > > + > > + /* The greed part is on gpio0.20 which is also used by > > green? Oops, sorry, thanks for catching. Willy