[PATCH] ASoC: bcm_2835: Simplify mono guard by returning error on mono

[hias@horus.com (Matthias Reichl)]

On Wed, Mar 08, 2017 at 09:58:54PM +1100, Matt Flax wrote:
> This patch simplifies the bcm2835_i2s.c code when the driver returns
> error on mono channel requests. It does this by testing for mono
> instead of using a switch statement to test for stereo.
> 
> The bcm2835_i2s driver can only work in stereo mode. Whilst leaving
> the driver entirel compliant with the I2S protocol, it simplifies the
> code by removing a few redundant lines of code.
> 
> Signed-off-by: Matt Flax <flatmax@flatmax.org>

I'm against this, it removes the semantics that I2S can only do 2
channels from the code part. Without looking at the rest of the code
one could get the impression that bcm2835-i2s could support all
layouts except 1 channel.

so long,

Hias

> ---
>  sound/soc/bcm/bcm2835-i2s.c | 17 +++++++++--------
>  1 file changed, 9 insertions(+), 8 deletions(-)
> 
> diff --git a/sound/soc/bcm/bcm2835-i2s.c b/sound/soc/bcm/bcm2835-i2s.c
> index 6ba2049..1e6a1da 100644
> --- a/sound/soc/bcm/bcm2835-i2s.c
> +++ b/sound/soc/bcm/bcm2835-i2s.c
> @@ -310,15 +310,16 @@ static int bcm2835_i2s_hw_params(struct snd_pcm_substream *substream,
>  	ch1pos = data_delay;
>  	ch2pos = bclk_ratio / 2 + data_delay;
>  
> -	switch (params_channels(params)) {
> -	case 2:
> -		format = BCM2835_I2S_CH1(format) | BCM2835_I2S_CH2(format);
> -		format |= BCM2835_I2S_CH1(BCM2835_I2S_CHPOS(ch1pos));
> -		format |= BCM2835_I2S_CH2(BCM2835_I2S_CHPOS(ch2pos));
> -		break;
> -	default:
> +	/* C
> +	 * Check we aren't setting channel 2 on a mono stream.
> +	 * We currently only support stereo
> +	 */
> +	if (params_channels(params) == 1)
>  		return -EINVAL;
> -	}
> +
> +	format = BCM2835_I2S_CH1(format) | BCM2835_I2S_CH2(format);
> +	format |= BCM2835_I2S_CH1(BCM2835_I2S_CHPOS(ch1pos));
> +	format |= BCM2835_I2S_CH2(BCM2835_I2S_CHPOS(ch2pos));
>  
>  	/*
>  	 * Set format for both streams.
> -- 
> 2.7.4
>