From: john@metanate.com (John Keeping)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v2 2/4] pinctrl: rockchip: convert to raw spinlock
Date: Wed, 15 Mar 2017 17:46:52 +0000 [thread overview]
Message-ID: <20170315174654.15128-3-john@metanate.com> (raw)
In-Reply-To: <20170315174654.15128-1-john@metanate.com>
This lock is used from rockchip_irq_set_type() which is part of the
irq_chip implementation and thus must use raw_spinlock_t as documented
in Documentation/gpio/driver.txt.
Signed-off-by: John Keeping <john@metanate.com>
Reviewed-by: Heiko Stuebner <heiko@sntech.de>
Tested-by: Heiko Stuebner <heiko@sntech.de>
---
v2: unchanged
---
drivers/pinctrl/pinctrl-rockchip.c | 30 +++++++++++++++---------------
1 file changed, 15 insertions(+), 15 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-rockchip.c b/drivers/pinctrl/pinctrl-rockchip.c
index 128c383ea7ba..8c1cae6d78d7 100644
--- a/drivers/pinctrl/pinctrl-rockchip.c
+++ b/drivers/pinctrl/pinctrl-rockchip.c
@@ -163,7 +163,7 @@ struct rockchip_pin_bank {
struct irq_domain *domain;
struct gpio_chip gpio_chip;
struct pinctrl_gpio_range grange;
- spinlock_t slock;
+ raw_spinlock_t slock;
u32 toggle_edge_mode;
};
@@ -1295,14 +1295,14 @@ static int rockchip_set_pull(struct rockchip_pin_bank *bank,
switch (ctrl->type) {
case RK2928:
- spin_lock_irqsave(&bank->slock, flags);
+ raw_spin_lock_irqsave(&bank->slock, flags);
data = BIT(bit + 16);
if (pull == PIN_CONFIG_BIAS_DISABLE)
data |= BIT(bit);
ret = regmap_write(regmap, reg, data);
- spin_unlock_irqrestore(&bank->slock, flags);
+ raw_spin_unlock_irqrestore(&bank->slock, flags);
break;
case RK1108:
case RK3188:
@@ -1503,7 +1503,7 @@ static int _rockchip_pmx_gpio_set_direction(struct gpio_chip *chip,
return ret;
clk_enable(bank->clk);
- spin_lock_irqsave(&bank->slock, flags);
+ raw_spin_lock_irqsave(&bank->slock, flags);
data = readl_relaxed(bank->reg_base + GPIO_SWPORT_DDR);
/* set bit to 1 for output, 0 for input */
@@ -1513,7 +1513,7 @@ static int _rockchip_pmx_gpio_set_direction(struct gpio_chip *chip,
data &= ~BIT(pin);
writel_relaxed(data, bank->reg_base + GPIO_SWPORT_DDR);
- spin_unlock_irqrestore(&bank->slock, flags);
+ raw_spin_unlock_irqrestore(&bank->slock, flags);
clk_disable(bank->clk);
return 0;
@@ -1963,7 +1963,7 @@ static void rockchip_gpio_set(struct gpio_chip *gc, unsigned offset, int value)
u32 data;
clk_enable(bank->clk);
- spin_lock_irqsave(&bank->slock, flags);
+ raw_spin_lock_irqsave(&bank->slock, flags);
data = readl(reg);
data &= ~BIT(offset);
@@ -1971,7 +1971,7 @@ static void rockchip_gpio_set(struct gpio_chip *gc, unsigned offset, int value)
data |= BIT(offset);
writel(data, reg);
- spin_unlock_irqrestore(&bank->slock, flags);
+ raw_spin_unlock_irqrestore(&bank->slock, flags);
clk_disable(bank->clk);
}
@@ -2083,7 +2083,7 @@ static void rockchip_irq_demux(struct irq_desc *desc)
data = readl_relaxed(bank->reg_base + GPIO_EXT_PORT);
do {
- spin_lock_irqsave(&bank->slock, flags);
+ raw_spin_lock_irqsave(&bank->slock, flags);
polarity = readl_relaxed(bank->reg_base +
GPIO_INT_POLARITY);
@@ -2094,7 +2094,7 @@ static void rockchip_irq_demux(struct irq_desc *desc)
writel(polarity,
bank->reg_base + GPIO_INT_POLARITY);
- spin_unlock_irqrestore(&bank->slock, flags);
+ raw_spin_unlock_irqrestore(&bank->slock, flags);
data_old = data;
data = readl_relaxed(bank->reg_base +
@@ -2125,20 +2125,20 @@ static int rockchip_irq_set_type(struct irq_data *d, unsigned int type)
return ret;
clk_enable(bank->clk);
- spin_lock_irqsave(&bank->slock, flags);
+ raw_spin_lock_irqsave(&bank->slock, flags);
data = readl_relaxed(bank->reg_base + GPIO_SWPORT_DDR);
data &= ~mask;
writel_relaxed(data, bank->reg_base + GPIO_SWPORT_DDR);
- spin_unlock_irqrestore(&bank->slock, flags);
+ raw_spin_unlock_irqrestore(&bank->slock, flags);
if (type & IRQ_TYPE_EDGE_BOTH)
irq_set_handler_locked(d, handle_edge_irq);
else
irq_set_handler_locked(d, handle_level_irq);
- spin_lock_irqsave(&bank->slock, flags);
+ raw_spin_lock_irqsave(&bank->slock, flags);
irq_gc_lock(gc);
level = readl_relaxed(gc->reg_base + GPIO_INTTYPE_LEVEL);
@@ -2181,7 +2181,7 @@ static int rockchip_irq_set_type(struct irq_data *d, unsigned int type)
break;
default:
irq_gc_unlock(gc);
- spin_unlock_irqrestore(&bank->slock, flags);
+ raw_spin_unlock_irqrestore(&bank->slock, flags);
clk_disable(bank->clk);
return -EINVAL;
}
@@ -2190,7 +2190,7 @@ static int rockchip_irq_set_type(struct irq_data *d, unsigned int type)
writel_relaxed(polarity, gc->reg_base + GPIO_INT_POLARITY);
irq_gc_unlock(gc);
- spin_unlock_irqrestore(&bank->slock, flags);
+ raw_spin_unlock_irqrestore(&bank->slock, flags);
clk_disable(bank->clk);
return 0;
@@ -2472,7 +2472,7 @@ static struct rockchip_pin_ctrl *rockchip_pinctrl_get_soc_data(
for (i = 0; i < ctrl->nr_banks; ++i, ++bank) {
int bank_pins = 0;
- spin_lock_init(&bank->slock);
+ raw_spin_lock_init(&bank->slock);
bank->drvdata = d;
bank->pin_base = ctrl->nr_pins;
ctrl->nr_pins += bank->nr_pins;
--
2.12.0.377.gf910686b23.dirty
next prev parent reply other threads:[~2017-03-15 17:46 UTC|newest]
Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-03-15 17:46 [PATCH v2 0/4] pinctrl: rockchip: PREEMPT_RT_FULL fixes John Keeping
2017-03-15 17:46 ` [PATCH v2 1/4] pinctrl: rockchip: remove unnecessary locking John Keeping
2017-03-15 18:51 ` [PATCH v2.1 " John Keeping
2017-03-23 9:03 ` [PATCH v2 " Linus Walleij
2017-03-15 17:46 ` John Keeping [this message]
2017-03-15 18:01 ` [PATCH v2 2/4] pinctrl: rockchip: convert to raw spinlock Julia Cartwright
2017-03-15 18:08 ` John Keeping
2017-03-15 18:16 ` Heiko Stuebner
2017-03-15 18:23 ` Julia Cartwright
2017-03-15 18:46 ` John Keeping
2017-03-15 17:46 ` [PATCH v2 3/4] pinctrl: rockchip: split out verification of mux settings John Keeping
2017-03-15 17:46 ` [PATCH v2 4/4] pinctrl: rockchip: avoid hardirq-unsafe functions in irq_chip John Keeping
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20170315174654.15128-3-john@metanate.com \
--to=john@metanate.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox