[PATCH 1/3] dt: bindings: add pmu0 regs for USB PHYs on Allwinner H3/V3s/A64

[icenowy@aosc.io (Icenowy Zheng)]

From: Icenowy Zheng <icenowy@aosc.xyz>

Allwinner H3/V3s/A64 SoCs have a special USB PHY0 that can route to two
controllers: one is MUSB and the other is a EHCI/OHCI pair.

When it's routed to EHCI/OHCI pair, it will needs a "pmu0" regs to
tweak, like other EHCI/OHCI pairs in Allwinner SoCs.

Add this to the binding of USB PHYs on Allwinner H3/V3s/A64.

Signed-off-by: Icenowy Zheng <icenowy@aosc.xyz>
Acked-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
---

Kishon, could you push this to 4.11?

 Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt | 1 +
 1 file changed, 1 insertion(+)

diff --git a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
index e42334258185..005bc22938ff 100644
--- a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
+++ b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
@@ -15,6 +15,7 @@ Required properties:
 - reg : a list of offset + length pairs
 - reg-names :
   * "phy_ctrl"
+  * "pmu0" for H3, V3s and A64
   * "pmu1"
   * "pmu2" for sun4i, sun6i or sun7i
 - #phy-cells : from the generic phy bindings, must be 1
-- 
2.12.2