[PATCH] iommu: Print a message with the default domain type created

[PATCH] iommu: Print a message with the default domain type created

[Robert Richter]

There are several ways the bypass mode can be enabled. With commit

 fccb4e3b8ab0 iommu: Allow default domain type to be set on the kernel command line

there is the option to switch into bypass mode. And, depending on
devicetree options, bypass mode can be also enabled. This makes it
hard to determine if direct mapping is enabled. Print message with the
default domain type case.

Signed-off-by: Robert Richter <rrichter@cavium.com>
---
 drivers/iommu/iommu.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/iommu/iommu.c b/drivers/iommu/iommu.c
index 3b67144dead2..ae84899dabd2 100644
--- a/drivers/iommu/iommu.c
+++ b/drivers/iommu/iommu.c
@@ -586,7 +586,9 @@ int iommu_group_add_device(struct iommu_group *group, struct device *dev)
 
 	trace_add_device_to_group(group->id, dev);
 
-	pr_info("Adding device %s to group %d\n", dev_name(dev), group->id);
+	pr_info("Adding device %s to group %d, default domain type %d\n",
+		dev_name(dev), group->id,
+		group->default_domain ? group->default_domain->type : -1);
 
 	return 0;
 
-- 
2.11.0

[PATCH] iommu: Print a message with the default domain type created

[Joerg Roedel]

Hi Robert,

On Wed, Apr 26, 2017 at 04:38:13PM +0200, Robert Richter wrote:
> -	pr_info("Adding device %s to group %d\n", dev_name(dev), group->id);
> +	pr_info("Adding device %s to group %d, default domain type %d\n",
> +		dev_name(dev), group->id,
> +		group->default_domain ? group->default_domain->type : -1);

Printing just a number is not very user-friendly. We have only two
default domain-types right now, so it is sufficient to just print
additional information if a device is identity-mapped. Something like

	"Adding device %s to group %d - using identity mapping"


Regards,

	Joerg