From mboxrd@z Thu Jan 1 00:00:00 1970 From: bjorn.andersson@linaro.org (Bjorn Andersson) Date: Wed, 26 Apr 2017 15:04:44 -0700 Subject: [PATCH 2/2] arm64: dts: apq8016-sbc: Correct WLAN LED default-trigger In-Reply-To: <20170426220444.10539-1-bjorn.andersson@linaro.org> References: <20170426220444.10539-1-bjorn.andersson@linaro.org> Message-ID: <20170426220444.10539-2-bjorn.andersson@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The TX status trigger of the wlan interface is named phy0tx, so this updates the default-trigger for the WLAN LED to use that instead. Signed-off-by: Bjorn Andersson --- Note that without patch 1/2 this trigger does not fire - but there's also no harm in picking the two patches through separate trees. arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi index 5d83b02b7c4a..21a8f5ce8955 100644 --- a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi +++ b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi @@ -178,7 +178,7 @@ led at 5 { label = "apq8016-sbc:yellow:wlan"; gpios = <&pm8916_mpps 2 GPIO_ACTIVE_HIGH>; - linux,default-trigger = "wlan"; + linux,default-trigger = "phy0tx"; default-state = "off"; }; -- 2.12.0