From mboxrd@z Thu Jan 1 00:00:00 1970 From: clabbe.montjoie@gmail.com (Corentin Labbe) Date: Fri, 8 Sep 2017 09:11:52 +0200 Subject: [PATCH v5 06/10] ARM: dts: sunxi: h3/h5: represent the mdio switch used by sun8i-h3-emac In-Reply-To: <20170908071156.5115-1-clabbe.montjoie@gmail.com> References: <20170908071156.5115-1-clabbe.montjoie@gmail.com> Message-ID: <20170908071156.5115-7-clabbe.montjoie@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Since dwmac-sun8i could use either an integrated PHY or an external PHY (which could be at same MDIO address), we need to represent this selection by a MDIO switch. Signed-off-by: Corentin Labbe --- arch/arm/boot/dts/sunxi-h3-h5.dtsi | 30 +++++++++++++++++++++++++----- 1 file changed, 25 insertions(+), 5 deletions(-) diff --git a/arch/arm/boot/dts/sunxi-h3-h5.dtsi b/arch/arm/boot/dts/sunxi-h3-h5.dtsi index 4b599b5d26f6..e137377b312d 100644 --- a/arch/arm/boot/dts/sunxi-h3-h5.dtsi +++ b/arch/arm/boot/dts/sunxi-h3-h5.dtsi @@ -417,14 +417,34 @@ #size-cells = <0>; status = "disabled"; - mdio: mdio { + mdio0: mdio { #address-cells = <1>; #size-cells = <0>; - int_mii_phy: ethernet-phy at 1 { - compatible = "ethernet-phy-ieee802.3-c22"; + compatible = "snps,dwmac-mdio"; + }; + + mdio-mux { + compatible = "mdio-mux"; + #address-cells = <1>; + #size-cells = <0>; + + /* Only one MDIO is usable at the time */ + internal_mdio: mdio at 1 { + reg = <0>; + #address-cells = <1>; + #size-cells = <0>; + int_mii_phy: ethernet-phy at 1 { + compatible = "ethernet-phy-ieee802.3-c22"; + reg = <1>; + clocks = <&ccu CLK_BUS_EPHY>; + resets = <&ccu RST_BUS_EPHY>; + phy-is-integrated; + }; + }; + mdio: mdio at 0 { reg = <1>; - clocks = <&ccu CLK_BUS_EPHY>; - resets = <&ccu RST_BUS_EPHY>; + #address-cells = <1>; + #size-cells = <0>; }; }; }; -- 2.13.5