defconfig'ed v4.13 does not boot on ThunderX

[mark.rutland@arm.com (Mark Rutland)]

On Wed, Oct 04, 2017 at 02:38:58PM +0100, Robin Murphy wrote:
> On 04/10/17 08:25, Itaru Kitayama wrote:
> > Hi,
> > 
> > defconfig'ed kernel v4.13 does not boot on ThunderX, leaving only
> > messages below:
> > 
> > EFI stub: Booting Linux Kernel...
> > EFI stub: Using DTB from configuration table
> > EFI stub: Exiting boot services and installing virtual address map...
> > 
> > Our HW is by GIGABYTE, the model is R150 T62 rev 100:
> > 
> > http://b2b.gigabyte.com/ARM-Server/R150-T62-rev-100#ov
> > 
> > The BIOS we're on is T43. Has anyone testing upstream kernels seen a
> > similar issue like this?
> 
> FWIW defconfig does *not* enable most of the ThunderX drivers (most
> importantly, PCI and networking will be missing).

.... it's a bit worrying if earlycon doesn't work without those, though.
It shouldn't be dependendent on either. :/

> I've just built the v4.13 tag with the appropriate drivers added and
> booted it on a different ThunderX box - the net core throws some
> warnings from __dev_xdp_attached() but it gets to userspace OK for me.

Given these seem to exist out in the field, we should probably enable
those drivers in defconfig.

Thanks,
Mark.