[RFC 5/5] pwm: pwm-omap-dmtimer: Add capture functionality

[ladis@linux-mips.org (Ladislav Michl)]

On Mon, Jan 08, 2018 at 02:13:27PM -0800, Tony Lindgren wrote:
> * Ladislav Michl <ladis@linux-mips.org> [180108 22:09]:
> > On Mon, Jan 08, 2018 at 01:59:31PM -0800, Tony Lindgren wrote:
> > > * Ladislav Michl <ladis@linux-mips.org> [180108 15:46]:
> > > > Here it seems hardware can capture both edges, but I do not see a way
> > > > how to tell it I want start from either low to high or high to low
> > > > transition. Clues?
> > > 
> > > At least dm3730 TRM documents TCM bits [9:8] for TCLR, but you
> > > probably know that already..
> > > 
> > > If you're having hard time getting things starting, maybe something
> > > like this helps:
> > > 
> > > stop timer in TCLR register
> > > configure timer in TCLR
> > > write some value to TLDR, maybe 0?
> > > set ST bit in TCLR to start
> > 
> > Let me clarify it a bit more. I have no problem starting timer and capture
> > events. I just didn't find a way how to tell hardware I want to start
> > with for example rising edge, so rising edge goes to TCAR1 and failing edge
> > to TCAR2. Substracting those gives pulse width.
> 
> Oh I see, yeah that would be cool :) Maybe you can first configure
> an interrupt to trigger on rising edge, then configure things for
> falling edge, then subtract..

That will work only for very long periods. I did test where value captured
into TCAR was compared to value read from TCRR. Sometimes those differ by
few hundreds microseconds...

I started this work to overcome GPIO edge interrupts latency, but so far
I'm a bit dissapointed.

(also please read the code, reconfiguration is done to get period and
duty cycle - but in case of duty cycle it is not clear whenever we are
measuring pulse or space length)

	ladis