From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@bootlin.com (Maxime Ripard) Date: Mon, 5 Feb 2018 14:36:25 +0100 Subject: [linux-sunxi] [PATCH v3] ARM: sun8i: h2+: add support for Banana Pi M2 Zero board In-Reply-To: References: <20171224054029.12278-1-icenowy@aosc.io> Message-ID: <20180205133625.vcz73qck5kfihalv@flea> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Sat, Feb 03, 2018 at 05:45:52PM +1100, Julian Calaby wrote: > Hi all, > > On Sun, Dec 24, 2017 at 4:40 PM, Icenowy Zheng wrote: > > Banana Pi M2 Zero board is a H2+-based board by Sinovoip, with a form > > factor and GPIO holes similar to Raspberry Pi Zero. > > > > It features: > > - Allwinner H2+ SoC > > - Single-chip (16-bit) 512MiB DDR3 DRAM > > - Ampak AP6212 Wi-Fi/Bluetooth module > > - MicroSD slot > > - Two MicroUSB Type-B ports (one can only be used to power the board and > > the other features OTG functionality) > > - Two keys, a reset and a GPIO-connected key. > > - HDMI Type-C (miniHDMI) connector connected to the HDMI part of H2+. > > - CSI connector to connect the camera sensor provided by Sinovoip. > > > > Signed-off-by: Icenowy Zheng > > [Trimmed lots of non-sunxi-specific mailing lists] > > Did support for this board ever get merged? It doesn't look like it did. > (I have two of them now, so if it didn't, I'll try to shepherd this > and it's corresponding u-boot patch upstream.) That sounds great :) Maxime -- Maxime Ripard, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering http://bootlin.com -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 833 bytes Desc: not available URL: