From: enric.balletbo@collabora.com (Enric Balletbo i Serra)
To: linux-arm-kernel@lists.infradead.org
Subject: [RFC PATCH 03/10] devfreq: rk3399_dmc: Pass ODT and auto power down parameters to TF-A.
Date: Mon, 14 May 2018 23:16:03 +0200 [thread overview]
Message-ID: <20180514211610.26618-4-enric.balletbo@collabora.com> (raw)
In-Reply-To: <20180514211610.26618-1-enric.balletbo@collabora.com>
Trusted Firmware-A (TF-A) for rk3399 implements a SiP call to get the
on-die termination (ODT) and auto power down parameters from kernel,
this patch adds the functionality to do this. Also, if DDR clock
frequency is lower than the on-die termination (ODT) disable frequency
this driver should disable the DDR ODT.
Signed-off-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>
---
drivers/devfreq/rk3399_dmc.c | 50 ++++++++++++++++++++++++++++-
include/soc/rockchip/rockchip_sip.h | 1 +
2 files changed, 50 insertions(+), 1 deletion(-)
diff --git a/drivers/devfreq/rk3399_dmc.c b/drivers/devfreq/rk3399_dmc.c
index d5c03e5abe13..cc1bbca3fb15 100644
--- a/drivers/devfreq/rk3399_dmc.c
+++ b/drivers/devfreq/rk3399_dmc.c
@@ -18,14 +18,17 @@
#include <linux/devfreq.h>
#include <linux/devfreq-event.h>
#include <linux/interrupt.h>
+#include <linux/mfd/syscon.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/platform_device.h>
#include <linux/pm_opp.h>
+#include <linux/regmap.h>
#include <linux/regulator/consumer.h>
#include <linux/rwsem.h>
#include <linux/suspend.h>
+#include <soc/rockchip/rk3399_grf.h>
#include <soc/rockchip/rockchip_sip.h>
struct dram_timing {
@@ -69,8 +72,11 @@ struct rk3399_dmcfreq {
struct mutex lock;
struct dram_timing timing;
struct regulator *vdd_center;
+ struct regmap *regmap_pmu;
unsigned long rate, target_rate;
unsigned long volt, target_volt;
+ unsigned int odt_dis_freq;
+ int odt_pd_arg0, odt_pd_arg1;
};
static int rk3399_dmcfreq_target(struct device *dev, unsigned long *freq,
@@ -80,6 +86,8 @@ static int rk3399_dmcfreq_target(struct device *dev, unsigned long *freq,
struct dev_pm_opp *opp;
unsigned long old_clk_rate = dmcfreq->rate;
unsigned long target_volt, target_rate;
+ struct arm_smccc_res res;
+ int dram_flag;
int err;
opp = devfreq_recommended_opp(dev, freq, flags);
@@ -95,6 +103,15 @@ static int rk3399_dmcfreq_target(struct device *dev, unsigned long *freq,
mutex_lock(&dmcfreq->lock);
+ dram_flag = 0;
+ if (target_rate >= dmcfreq->odt_dis_freq)
+ dram_flag = 1;
+
+ arm_smccc_smc(ROCKCHIP_SIP_DRAM_FREQ, dmcfreq->odt_pd_arg0,
+ dmcfreq->odt_pd_arg1,
+ ROCKCHIP_SIP_CONFIG_DRAM_SET_ODT_PD,
+ dram_flag, 0, 0, 0, &res);
+
/*
* If frequency scaling from low to high, adjust voltage first.
* If frequency scaling from high to low, adjust frequency first.
@@ -294,11 +311,13 @@ static int rk3399_dmcfreq_probe(struct platform_device *pdev)
{
struct arm_smccc_res res;
struct device *dev = &pdev->dev;
- struct device_node *np = pdev->dev.of_node;
+ struct device_node *np = pdev->dev.of_node, *node;
struct rk3399_dmcfreq *data;
int ret, index, size;
uint32_t *timing;
struct dev_pm_opp *opp;
+ u32 ddr_type;
+ u32 val;
data = devm_kzalloc(dev, sizeof(struct rk3399_dmcfreq), GFP_KERNEL);
if (!data)
@@ -334,6 +353,29 @@ static int rk3399_dmcfreq_probe(struct platform_device *pdev)
return ret;
}
+ /* Try to find the optional reference to the pmu syscon */
+ node = of_parse_phandle(np, "rockchip,pmu", 0);
+ if (node) {
+ data->regmap_pmu = syscon_node_to_regmap(node);
+ if (IS_ERR(data->regmap_pmu))
+ return PTR_ERR(data->regmap_pmu);
+ }
+
+ /* Get DDR type */
+ regmap_read(data->regmap_pmu, RK3399_PMUGRF_OS_REG2, &val);
+ ddr_type = (val >> RK3399_PMUGRF_DDRTYPE_SHIFT) &
+ RK3399_PMUGRF_DDRTYPE_MASK;
+
+ /* Get the odt_dis_freq parameter in function of the DDR type */
+ if (ddr_type == RK3399_PMUGRF_DDRTYPE_DDR3)
+ data->odt_dis_freq = data->timing.ddr3_odt_dis_freq;
+ else if (ddr_type == RK3399_PMUGRF_DDRTYPE_LPDDR3)
+ data->odt_dis_freq = data->timing.lpddr3_odt_dis_freq;
+ else if (ddr_type == RK3399_PMUGRF_DDRTYPE_LPDDR4)
+ data->odt_dis_freq = data->timing.lpddr4_odt_dis_freq;
+ else
+ return -EINVAL;
+
/*
* Get dram timing and pass it to arm trust firmware,
* the dram drvier in arm trust firmware will get these
@@ -358,6 +400,12 @@ static int rk3399_dmcfreq_probe(struct platform_device *pdev)
ROCKCHIP_SIP_CONFIG_DRAM_INIT,
0, 0, 0, 0, &res);
+ data->odt_pd_arg0 = (data->timing.sr_idle & 0xff) |
+ ((data->timing.sr_mc_gate_idle & 0xff) << 8) |
+ ((data->timing.standby_idle & 0xffff) << 16);
+ data->odt_pd_arg1 = (data->timing.pd_idle & 0xfff) |
+ ((data->timing.srpd_lite_idle & 0xfff) << 16);
+
/*
* We add a devfreq driver to our parent since it has a device tree node
* with operating points.
diff --git a/include/soc/rockchip/rockchip_sip.h b/include/soc/rockchip/rockchip_sip.h
index 7e28092c4d3d..ad9482c56797 100644
--- a/include/soc/rockchip/rockchip_sip.h
+++ b/include/soc/rockchip/rockchip_sip.h
@@ -23,5 +23,6 @@
#define ROCKCHIP_SIP_CONFIG_DRAM_GET_RATE 0x05
#define ROCKCHIP_SIP_CONFIG_DRAM_CLR_IRQ 0x06
#define ROCKCHIP_SIP_CONFIG_DRAM_SET_PARAM 0x07
+#define ROCKCHIP_SIP_CONFIG_DRAM_SET_ODT_PD 0x08
#endif
--
2.17.0
next prev parent reply other threads:[~2018-05-14 21:16 UTC|newest]
Thread overview: 21+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-05-14 21:16 [RFC PATCH 00/10] Add support for drm/rockchip to dynamically control the DDR frequency Enric Balletbo i Serra
2018-05-14 21:16 ` [RFC PATCH 01/10] devfreq: rockchip-dfi: Move GRF definitions to a common place Enric Balletbo i Serra
2018-05-14 21:44 ` Chanwoo Choi
2018-05-15 11:23 ` Robin Murphy
2018-05-14 21:16 ` [RFC PATCH 02/10] dt-bindings: devfreq: rk3399_dmc: Add rockchip, pmu phandle Enric Balletbo i Serra
2018-05-14 22:20 ` [RFC PATCH 02/10] dt-bindings: devfreq: rk3399_dmc: Add rockchip,pmu phandle Chanwoo Choi
2018-05-22 22:45 ` Rob Herring
2018-05-14 21:16 ` Enric Balletbo i Serra [this message]
2018-05-14 22:20 ` [RFC PATCH 03/10] devfreq: rk3399_dmc: Pass ODT and auto power down parameters to TF-A Chanwoo Choi
2018-06-16 10:15 ` Enric Balletbo Serra
2018-06-17 0:00 ` Chanwoo Choi
2018-05-14 21:16 ` [RFC PATCH 04/10] devfreq: rk3399_dmc / rockchip: pm_domains: Register notify to DMC driver Enric Balletbo i Serra
2018-05-18 2:44 ` Chanwoo Choi
2018-05-14 21:16 ` [RFC PATCH 05/10] devfreq: rk3399_dmc / clk: rockchip: Sync with vblank in the kernel for DDRfreq Enric Balletbo i Serra
2018-05-14 21:16 ` [RFC PATCH 06/10] devfreq: rk3399_dmc / clk: rockchip: Disable DDR clk timeout on suspend Enric Balletbo i Serra
2018-05-14 21:16 ` [RFC PATCH 07/10] clk: rockchip: set clk-ddr to GET_RATE_NOCACHE Enric Balletbo i Serra
2018-05-15 20:41 ` Stephen Boyd
2018-05-14 21:16 ` [RFC PATCH 08/10] drm: rockchip: Add DDR devfreq support Enric Balletbo i Serra
2018-05-14 21:16 ` [RFC PATCH 09/10] arm64: dts: rk3399: Add dfi and dmc nodes Enric Balletbo i Serra
2018-05-22 22:51 ` Rob Herring
2018-05-14 21:16 ` [RFC PATCH 10/10] arm64: dts: rockchip: Enable dmc and dfi nodes on gru Enric Balletbo i Serra
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20180514211610.26618-4-enric.balletbo@collabora.com \
--to=enric.balletbo@collabora.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox