From mboxrd@z Thu Jan 1 00:00:00 1970 From: antoine.tenart@bootlin.com (Antoine Tenart) Date: Thu, 17 May 2018 10:29:39 +0200 Subject: [PATCH net-next v3 10/10] arm64: dts: marvell: 7040-db: describe the 10G interface as fixed-link In-Reply-To: <20180517082939.14598-1-antoine.tenart@bootlin.com> References: <20180517082939.14598-1-antoine.tenart@bootlin.com> Message-ID: <20180517082939.14598-11-antoine.tenart@bootlin.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch adds a fixed-link node to the 10G interface of the 7040-db board. This is required as the mvpp2 driver now uses phylink. The best solution would have been to describe the SFP cage but they are not wired correctly, and thus unusable, so we chose to use fixed-link instead. Signed-off-by: Antoine Tenart --- arch/arm64/boot/dts/marvell/armada-7040-db.dts | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/arch/arm64/boot/dts/marvell/armada-7040-db.dts b/arch/arm64/boot/dts/marvell/armada-7040-db.dts index d6bec058a30a..412efdb46e7c 100644 --- a/arch/arm64/boot/dts/marvell/armada-7040-db.dts +++ b/arch/arm64/boot/dts/marvell/armada-7040-db.dts @@ -242,6 +242,11 @@ phy-mode = "10gbase-kr"; /* Generic PHY, providing serdes lanes */ phys = <&cp0_comphy2 0>; + + fixed-link { + speed = <10000>; + full-duplex; + }; }; &cp0_eth1 { -- 2.17.0