From mboxrd@z Thu Jan 1 00:00:00 1970 From: embed3d@gmail.com (Philipp Rossak) Date: Thu, 30 Aug 2018 17:45:15 +0200 Subject: [PATCH v3 27/30] ARM: dts: sun8i: h3: use calibration for ths In-Reply-To: <20180830154518.29507-1-embed3d@gmail.com> References: <20180830154518.29507-1-embed3d@gmail.com> Message-ID: <20180830154518.29507-28-embed3d@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The H3 SID is supported by the kernel so we can add a NVMEM Data cell, that contains the calibration data. On the H3 the eFuses are located at the offset 0x200. The thermal data itself has an offset of 0x34 from the eFuse base. So we end on an offset of 0x234. Signed-off-by: Philipp Rossak --- arch/arm/boot/dts/sun8i-h3.dtsi | 9 +++++++++ 1 file changed, 9 insertions(+) diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi index 1866aec69ec1..0fc447f0c02a 100644 --- a/arch/arm/boot/dts/sun8i-h3.dtsi +++ b/arch/arm/boot/dts/sun8i-h3.dtsi @@ -106,8 +106,15 @@ soc { sid: eeprom at 1c14000 { + #address-cells = <1>; + #size-cells = <1>; compatible = "allwinner,sun8i-h3-sid"; reg = <0x01c14000 0x400>; + + /* Data cells */ + thermal_calibration: calib at 234 { + reg = <0x234 0x8>; + }; }; }; @@ -227,4 +234,6 @@ &ths { compatible = "allwinner,sun8i-h3-ths"; #thermal-sensor-cells = <0>; + nvmem-cells = <&thermal_calibration>; + nvmem-cell-names = "calibration"; }; -- 2.11.0