From mboxrd@z Thu Jan 1 00:00:00 1970 From: lkundrak@v3.sk (Lubomir Rintel) Date: Tue, 13 Nov 2018 11:22:26 +0100 Subject: [PATCH v3 4/6] spi: pxa2xx: dt-bindings: Add ready GPIO signal In-Reply-To: <20181113102228.820214-1-lkundrak@v3.sk> References: <20181113102228.820214-1-lkundrak@v3.sk> Message-ID: <20181113102228.820214-5-lkundrak@v3.sk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This this is used to let the SPI master know that our FIFO is filled and we're ready to service a transfer. Only useful in slave mode. A signal like this is used by an embedded controller on a OLPC XO 1.75 machine, that happens to be a SPI master. Signed-off-by: Lubomir Rintel Acked-by: Pavel Machek --- Changes since v2: - s/ready-gpio/ready-gpios/ - Updated the subject line to conform with subsystem customs Documentation/devicetree/bindings/spi/spi-pxa2xx.txt | 2 ++ 1 file changed, 2 insertions(+) diff --git a/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt b/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt index 89b2832283e3..e30e0c2a4bce 100644 --- a/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt +++ b/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt @@ -12,6 +12,8 @@ Optional properties: - cs-gpios: list of GPIO chip selects. See the SPI bus bindings, Documentation/devicetree/bindings/spi/spi-bus.txt - spi-slave: Empty property indicating the SPI controller is used in slave mode. +- ready-gpios: GPIO used to signal a SPI master that the FIFO is filled + and we're ready to service a transfer. Only useful in slave mode. Child nodes represent devices on the SPI bus See ../spi/spi-bus.txt -- 2.19.1