From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@bootlin.com (Maxime Ripard) Date: Tue, 20 Nov 2018 08:58:03 +0100 Subject: [PATCH 0/3] arm64: dts: allwinner: h6: orangepi: Enable USB 2.0 and LEDs In-Reply-To: <20181120065311.30009-1-wens@csie.org> References: <20181120065311.30009-1-wens@csie.org> Message-ID: <20181120075803.6735awl2zd5ak2fo@flea> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Nov 20, 2018 at 02:53:08PM +0800, Chen-Yu Tsai wrote: > Hi, > > This small series enables USB 2.0 and LEDs on the Orange Pi Lite 2 and > Orange Pi One Plus. The two features are unrelated, but included in the > same series as the patch contexts overlap. > > Patch one adds a fixed regulator to represent the board-wide 5V rail. > While not strictly necessary, this helps define the relationship between > regulators. > > Patch two enables USB 2.0 host and OTG. Note that VBUS on both ports are > directly tied to the 5V rail, without any power switches or current > limiters. > > Patch three add device nodes for the two LEDs. These LEDs are driven > directly by the GPIO pins, without a current limiting resistor. At the > default drive strength, the LEDs are quite bright. Applied all three patches, thanks! Maxime -- Maxime Ripard, Bootlin Embedded Linux and Kernel engineering https://bootlin.com -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 228 bytes Desc: not available URL: