From mboxrd@z Thu Jan 1 00:00:00 1970 From: miquel.raynal@bootlin.com (Miquel Raynal) Date: Fri, 23 Nov 2018 17:17:27 +0100 Subject: [PATCH v2 3/6] dt-bindings: ap806: document the thermal interrupt capabilities In-Reply-To: <20181123161730.11289-1-miquel.raynal@bootlin.com> References: <20181123161730.11289-1-miquel.raynal@bootlin.com> Message-ID: <20181123161730.11289-4-miquel.raynal@bootlin.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The thermal IP can produce interrupts on overheat situation. Describe them. Signed-off-by: Miquel Raynal --- .../bindings/arm/marvell/ap806-system-controller.txt | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt b/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt index 3fd21bb7cb37..35e8dd2edfd2 100644 --- a/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt +++ b/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt @@ -114,12 +114,18 @@ Documentation/devicetree/bindings/thermal/thermal.txt The thermal IP can probe the temperature all around the processor. It may feature several channels, each of them wired to one sensor. +It is possible to setup an overheat interrupt by giving at least one +critical point to any subnode of the thermal-zone node. + Required properties: - compatible: must be one of: * marvell,armada-ap806-thermal - reg: register range associated with the thermal functions. Optional properties: +- interrupt-parent/interrupts: overheat interrupt handle. Should point to + line 18 of the SEI irqchip. + See interrupt-controller/interrupts.txt - #thermal-sensor-cells: shall be <1> when thermal-zones subnodes refer to this IP and represents the channel ID. There is one sensor per channel. O refers to the thermal IP internal channel, while positive @@ -133,6 +139,8 @@ ap_syscon1: system-controller at 6f8000 { ap_thermal: thermal-sensor at 80 { compatible = "marvell,armada-ap806-thermal"; reg = <0x80 0x10>; + interrupt-parent = <&sei>; + interrupts = <18>; #thermal-sensor-cells = <1>; }; }; -- 2.19.1