From: Linus Walleij <linus.walleij@linaro.org>
To: linux-arm-kernel@lists.infradead.org,
Imre Kaloz <kaloz@openwrt.org>,
Krzysztof Halasa <khalasa@piap.pl>
Cc: devicetree@vger.kernel.org, Arnd Bergmann <arnd@arndb.de>,
Tim Harvey <tharvey@gateworks.com>,
Bartosz Golaszewski <bgolaszewski@baylibre.com>,
Olof Johansson <olof@lixom.net>,
Linus Walleij <linus.walleij@linaro.org>
Subject: [PATCH 13/17 v1] gpio: ixp4xx: Add DT bindings
Date: Sun, 3 Feb 2019 22:42:01 +0100 [thread overview]
Message-ID: <20190203214205.13594-14-linus.walleij@linaro.org> (raw)
In-Reply-To: <20190203214205.13594-1-linus.walleij@linaro.org>
This adds DT bindings for the IXP4xx GPIO controller.
Cc: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Cc: devicetree@vger.kernel.org
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
---
Bartosz: looking for your ACK on this, it'd be good if
the other GPIO maintainer is aligned with my ideas here.
I intend to merge this through the ARM SoC tree.
---
.../bindings/gpio/intel,ixp4xx-gpio.txt | 38 +++++++++++++++++++
MAINTAINERS | 1 +
2 files changed, 39 insertions(+)
create mode 100644 Documentation/devicetree/bindings/gpio/intel,ixp4xx-gpio.txt
diff --git a/Documentation/devicetree/bindings/gpio/intel,ixp4xx-gpio.txt b/Documentation/devicetree/bindings/gpio/intel,ixp4xx-gpio.txt
new file mode 100644
index 000000000000..8dc41ed99685
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/intel,ixp4xx-gpio.txt
@@ -0,0 +1,38 @@
+Intel IXP4xx XScale Networking Processors GPIO
+
+This GPIO controller is found in the Intel IXP4xx processors.
+It supports 16 GPIO lines.
+
+The interrupt portions of the GPIO controller is hierarchical:
+the synchronous edge detector is part of the GPIO block, but the
+actual enabling/disabling of the interrupt line is done in the
+main IXP4xx interrupt controller which has a 1:1 mapping for
+the first 12 GPIO lines to 12 system interrupts.
+
+The remaining 4 GPIO lines can not be used for receiving
+interrupts.
+
+The interrupt parent of this GPIO controller must be the
+IXP4xx interrupt controller.
+
+Required properties:
+
+- compatible : Should be
+ "intel,ixp4xx-gpio"
+- reg : Should contain registers location and length
+- gpio-controller : marks this as a GPIO controller
+- #gpio-cells : Should be 2, see gpio/gpio.txt
+- interrupt-controller : marks this as an interrupt controller
+- #interrupt-cells : a standard two-cell interrupt, see
+ interrupt-controller/interrupts.txt
+
+Example:
+
+gpio0: gpio@c8004000 {
+ compatible = "intel,ixp4xx-gpio";
+ reg = <0xc8004000 0x1000>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+};
diff --git a/MAINTAINERS b/MAINTAINERS
index 775a623dc91d..57d098b85523 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -1650,6 +1650,7 @@ M: Imre Kaloz <kaloz@openwrt.org>
M: Krzysztof Halasa <khalasa@piap.pl>
L: linux-arm-kernel@lists.infradead.org (moderated for non-subscribers)
S: Maintained
+F: Documentation/devicetree/bindings/gpio/intel,ixp4xx-gpio.txt
F: Documentation/devicetree/bindings/interrupt-controller/intel,ixp4xx-interrupt.txt
F: Documentation/devicetree/bindings/timer/intel,ixp4xx-timer.txt
F: arch/arm/mach-ixp4xx/
--
2.20.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2019-02-03 21:45 UTC|newest]
Thread overview: 43+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-02-03 21:41 [PATCH 00/17 v1] ARM: ixp4xx: Modernize and DT support Linus Walleij
2019-02-03 21:41 ` [PATCH 01/17 v1] ARM: ixp4xx: Convert to MULTI_IRQ_HANDLER Linus Walleij
2019-02-03 21:41 ` [PATCH 02/17 v1] ARM: ixp4xx: Pass IRQ resource to beeper Linus Walleij
2019-02-03 21:41 ` [PATCH 03/17 v1] ARM: ixp4xx: Convert to SPARSE_IRQ Linus Walleij
2019-02-03 21:41 ` [PATCH 04/17 v1] irqchip: Add driver for IXP4xx Linus Walleij
2019-02-11 15:30 ` Marc Zyngier
2019-02-11 20:58 ` Linus Walleij
2019-02-11 22:11 ` Marc Zyngier
2019-02-18 7:06 ` Krzysztof Hałasa
2019-02-18 7:16 ` Linus Walleij
2019-02-18 7:35 ` Krzysztof Hałasa
2019-02-18 9:40 ` Arnd Bergmann
2019-02-18 12:03 ` Krzysztof Hałasa
2019-02-18 12:44 ` Arnd Bergmann
2019-02-19 6:51 ` Krzysztof Hałasa
2019-02-19 9:46 ` Arnd Bergmann
2019-02-20 7:35 ` Krzysztof Hałasa
2019-02-18 9:18 ` Arnd Bergmann
2019-02-03 21:41 ` [PATCH 05/17 v1] gpio: ixp4xx: Add driver for the IXP4xx GPIO Linus Walleij
2019-02-06 16:03 ` Bartosz Golaszewski
2019-02-21 8:50 ` Linus Walleij
2019-02-03 21:41 ` [PATCH 06/17 v1] ARM: ixp4xx: Switch to use new IRQ+GPIO drivers Linus Walleij
2019-02-03 21:41 ` [PATCH 07/17 v1] clocksource/drivers/ixp4xx: Add driver Linus Walleij
2019-02-03 21:41 ` [PATCH 08/17 v1] ARM: ixp4xx: Switch to use new timer driver Linus Walleij
2019-02-03 21:41 ` [PATCH 09/17 v1] irqchip: ixp4xx: Add DT bindings Linus Walleij
2019-02-18 21:25 ` Rob Herring
2019-02-03 21:41 ` [PATCH 10/17 v1] irqchip: ixp4xx: Add OF initialization support Linus Walleij
2019-02-03 21:41 ` [PATCH 11/17 v1] clocksource/drivers/ixp4xx: Add DT bindings Linus Walleij
2019-02-18 21:26 ` Rob Herring
2019-02-18 22:10 ` Daniel Lezcano
2019-02-03 21:42 ` [PATCH 12/17 v1] clocksource/drivers/ixp4xx: Add OF initialization support Linus Walleij
2019-02-11 11:26 ` Daniel Lezcano
2019-02-03 21:42 ` Linus Walleij [this message]
2019-02-06 16:05 ` [PATCH 13/17 v1] gpio: ixp4xx: Add DT bindings Bartosz Golaszewski
2019-02-18 21:27 ` Rob Herring
2019-02-03 21:42 ` [PATCH 14/17 v1] gpio: ixp4xx: Add OF probing support Linus Walleij
2019-02-06 16:13 ` Bartosz Golaszewski
2019-02-21 8:55 ` Linus Walleij
2019-02-03 21:42 ` [PATCH 15/17 v1] ARM: ixp4xx: Add DT bindings Linus Walleij
2019-02-04 15:16 ` Rob Herring
2019-02-08 19:37 ` Linus Walleij
2019-02-03 21:42 ` [PATCH 16/17 v1] ARM: ixp4xx: Add device tree boot support Linus Walleij
2019-02-03 21:42 ` [PATCH 17/17 v1] RFC: ARM: dts: Add some initial IXP4xx device trees Linus Walleij
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190203214205.13594-14-linus.walleij@linaro.org \
--to=linus.walleij@linaro.org \
--cc=arnd@arndb.de \
--cc=bgolaszewski@baylibre.com \
--cc=devicetree@vger.kernel.org \
--cc=kaloz@openwrt.org \
--cc=khalasa@piap.pl \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=olof@lixom.net \
--cc=tharvey@gateworks.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).